|Prev||Professional Automotive Repair Technical Discussions for November 14, 2010
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1993 Ford Ranger XLT 3.0L fail visual inspect VIN: 1FTCR14U0P
i test a vehicle for emission. label on vehicle states one catalytic converter. my emission book states"type, twc+dual brick; number of catalytic converters 1". the vehicle has 2 cats. 1 non original. 1 aftermarket was install with orginal. i fail the vechicle...
|1997 Ford F-150 4.6L 4WD/Power windows VIN: 1FTDF18W4V
When putting vehicle into 4WD the 4WD light will sometimes go on and off intermittently. When this happens the power windows will not go up or down until the 4WD light comes back on, then the power windows operate normal until the 4WD light goes out again. I c...
|1999 Ford Ranger XLT 4.0L FRONT End VIN: 1FTZR15X3X
This ford ranger has a hum in the front that at first sounded like a bad wheel bearing, although i can get it to vary by moving the steering wheel back and forth. I changed the left front wheel bearing with no change. The strange part is it goes away when in 4...
|2000 Ford Explorer Sport 4.0L Excessive Emissions, Surge VIN: 1FMYU70E5Y
Cust replaced engine from junkyard, fuel trims will go crazy , ltft b1 will go -25 ltft b2 will go +25, stft b1 -23 stft b2 42.9, o2 sensors will go o2 b1s1 .91 o2 b1s2 .01 o2 b2s1 .0 o2 b2s2.94 will get codes p1127,p1131,p1132 and p1151 and misfire codes for...
|2002 Ford E-250 Econoline 4.2L Poor Idle Quality VIN: 1FTNS24292
hello everyone when i start this van it idles up high rpm and then slowes down to normal. not sure if this is normal.replaced iac sol. did,ent change. has no codes.thanks for any help
Fixes & Summaries for Ford
|1998 Ford Expedition XLT 5.4L Hesitation, Misfire, MIL Lamp on VIN: 1FMPU18L0W
well never fixed it.Thought it was good after 50 miles ran good then right back to misfiring. Think either another injector(unlikely ) or hiden harness or pcm problem. Just too random to determine. Thing is have another customer coming in with same complaint n... Trouble codes: P0307.
|2000 Ford F-250 Super Duty XLT 6.8L 1-2,2-3 shift VIN: 1FTNW21S7Y
Sorry for taking so long to respond. I have been in the hospital with a blood clot in one lung.Found a broken wire in the harness just before the speed sensor in the rear end that was losing contact intermittently. Thanks for all the replies.It put me in the r...
|2004 Ford F-450 Super Duty XL 6.0L overdrive VIN: 1FDXF46P34
well I learned that you can't fix something thats not broken. driver claimed he could not feel torque converter lock up. the first problem was the vetronics scanner that showed a -40f value for the mat sensor. installed a different scanner and that sensor did ...
|2005 Ford Explorer XLT 4.0L temp blend door mtr VIN: 1FMZU73E25
thanks to all that replied. All 3 were correct, you do not have to remove instrument panel,just center console , radio bezel and D/S lower dash panel, a little patience and approx 1.5 hrs. Once again thank you
|2005 Ford Crown Victoria Police Interceptor 4.6L No Start VIN: 2FAFP71W75
This turned out to be a blown fuse.It was located in the CJB under the dash #24. I missed the Text about that fuse, when I was looking at the owners manual on fuse locations. Thanks for all the quick responses. this site is truly amazing.