Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for October 10, 2010
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1988 Ford E-350 Econoline Custom 5.8L Poor Idle Quality VIN: 1FDKE37H7J
OK I need a EEC IV specialist ,This van idles fast (around 1500 RPM) . When you start it and don't touch the gas it will idle fine (650-750 rpm). If you give it gas the idle stays up, turn it off and start it again and it idles fine until you hit the gas. If y... Trouble codes: 13 (Unable to lower idle)
2006 Ford Taurus SE 3.0L starter VIN: 1FAFP53U86
Car came in with very intermintent grinding when trying to start. Starter was replaced, ring gear filed bacause one area about two inches long showed some wear of about .060 of a inch , maybe 6 to 8 teeth, but din't look too bad to me. Came back days later sam...

Fixes & Summaries for Ford
Fix/Summary Answers
2005 Ford Ranger XL 3.0L MIL Lamp on VIN: 1FTYR10U65
Thanks guys for the replies. Most of replies suggested I might have a problem with the injectors. One reminded me to make sure the O2 sensors would go to full rich with propane. I had checked the fuel rail for dirt, I had it apart twice. Once to swap injec... Trouble codes: P0174 (Lean Bank two).
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next