|Prev||Professional Automotive Repair Technical Discussions for May 29, 2010
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|2000 Honda Accord EX 2.3L oil burning VIN: JHMCG5554Y
This 2000 EX 4 dr with an F23A1 engine was built in Japan. Although compression is good it has begun to burn oil and may need an overhaul. I am identifying parts sources prior to disassembling the engine. Honda built this model in both the US and in Japan and ...
|1997 Nissan 200SX SE-R 2.0L Surge, Cuts out VIN: 1N4BB42D9V
vehicle misses/sputters on acceleration. no dtc, fuel press and regulator ok maf lab scope is good suspect coil/distributor, primary resistance is 1 ohm within spec but secondary is 17.86k ohms specs says around 10k seems kinda high, but a new dist is 300 doll...
|2008 Nissan Titan LE 5.6L No Start, no mil VIN: 1N6AA07D88
This one is for the nissan techs out there. I have this 08 titan with a crank but no start. Hooked up my scanner and scanner would not communicate with ecu. I found code u1000 and c1735 ign fault in bcm and tcm. I also noticed that the MIL will not turn on. I ... Trouble codes: U1000
Fixes & Summaries for Asian
|2000 Mazda Protege DX 1.6L Hesitation, Surge VIN: JM18J2236Y
I guess I can finally say this car is fixed. Looks like the egr valve curred the problem. Just a matter of physically checking it off the car.
|2002 Nissan Maxima SE 3.5L clattering under lite load VIN: JN1DA31D72
The problem was the variable valve timing chains and sprocket making the noise, similar to a spark knock or clatter. I disabled the solenoids to the variable valve timing and the noise mostly went away. That is how I keyed in,with the advise from others, what ...