Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 14, 2010
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1996 Ford F-250 XLT 7.3L No Start
hello. vehicle will lose high pressure oil after running for about twenty minutes high pressure oil will only climb to about two hundred psi have verified icp sensor is good non biased and replace oil pressure regulator with no change in outcome. suspicious of...
View
1998 Ford Mustang GT 4.6L No Start VIN: 1FAFP45X6W
Hello to all, thanks in advance for any help. This mustang cane in for running poorly. I found the fuel pressures to be under spec, i replaced the fuel pump and preformed motorvac. When motorvacing i left the fuel pump connector disconnected to prevent pump op... Trouble codes: U1147 (Scp data fault for vehicle security)
View
1999 Ford F-250 XLT 5.4L steering
I have this f250 that every once and awhile the steering gets hard. i was checking the front end over and i noticed that u can move the axles around freely and they have alot of play. i took the 4x4 hub off and noticed that it has some play in the spline. i th...
View
2000 Ford F-250 Super Duty XLT 7.3L No Start VIN: 1FTNX21F1Y
vehicle ran out of gas and I can't get it to prime can't find any bleeding procedures in alldata. thanks for any help
View
2005 Ford F-250 Super Duty XLT 6.0L High Pressure Oil System VIN: 1FTSX20P95
Truck ran fine, but engine oil cooler was leaking. Disassembled and replaced oil cooler and seals, changed engine oil and filter at the same time. Insides of the engine look as-new. After reassembling everything, the engine started up and ran fine. Temperature...
View
2005 Ford Escape Limited 3.0L noise VIN: 1FMYU93145
SUV has poping(popcorn)sound at idle only.All data looks good.Fuel pressure is good.Take engine off idle and noise goes away does not return until idle is back.Have replaced IAC motor and engine controler with brand new one from ford.This was done with advise ...
View
2006 Ford Ranger XLT 4.0L Hesitation, Cuts out, no power above 3,000 VIN: 1FTZR45E46
Vehicle loses power at 3,000 rpm, engine sounds like its up against a rev. limiter...hunting and surging...i know ive seen this before, but i cant remember what it was..lol im not getting any codes, however i am seeing a rich condition when i try to rev the en...
View

Fixes & Summaries for Ford
Fix/Summary Answers
1990 Ford Ranger Custom 2.3L engine VIN: 1FTCR10A0L
For all that helped, I really appriciate the help from all. The problem ended up being 2 clogged fuel injectors. I had compression, timing, spark, and fuel. That's why I was so stuck. After I sprayed starting fluid in durring it running and it smoothing out, I...
22
1999 Ford F-350 Super Duty XL 6.8L vibration VIN: 1FTWW33S3X
This is not fixed. The customer has taken the Truck back everyday. I want to fix this rig. But I just don't have the truck long enough to get a handle on the problem. I we have improved the vibration by changing the brake pads. I think the rest of the vib...
10
1999 Ford F-250 Super Duty XL 7.3L no turbo boost VIN: 1FTNX21FXX
Turbo locked up finally and made this issue fairly obvious. thanks for the help. Trouble codes: P0478, P0475, P0473, P0470.
7
1999 Ford Mustang SVT Cobra 4.6L Cuts out, Stall, MIL Lamp on VIN: 1FAFP46V3X
I found a burnt three pin connector under the airbox. Replaced the connector and drove fifty mile and no problems. Thanks for all the replies. Trouble codes: P1233.
7
2003 Ford Taurus SE 3.0L horn VIN: 1FAFP55273
Just wanted to thank every one who replied to my request. The cruse control servo was disconected. Once again thank you for your time.
12
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next