Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 2, 2010
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
2002 Ford F-550 Super Duty XL 7.3L No Start VIN: 1XDXF46F52
The vehicle started OK after replacement of the cover gasket/pigtail assy. Cranking time was a little extended but it ran great!!! It ran non stop all night and this morning would not start. Cranks kinda fast but fuel pressure good. Fuses good. No codes. I hav...
2002 Ford Taurus SE 4-Valve 3.0L rt wheel VIN: 1FAFP56S12
ran car, and right wheel thumps with and without applied brakes. noise is more pronounced when turning to left and loading wheel, remember i replaced axle,hub/bearing,rotors and i removed right cal assembly then road tested with same problem. thanks for info h...
2007 Ford F-150 XL 5.4L Timing chain VIN: 1FTPW12527
Greetings,I'm looking for some direction here. This is my first experience with one of these. Vehicle came in with noise and runs bad complaint. Was 2 qt low and sounded like timing chain was hitting, very loud, not the normal noises from this engine. It als...

Fixes & Summaries for Ford
Fix/Summary Answers
1995 Ford F-250 XL 7.5L Gear selection VIN: 1FTHX25FXS
Just as many of you said the break lamp fuse was blown. Found short where trailer harness had cracked installation rubbing on bumper. Problem solved. The one thing I do not understand though is why were we able to move the lever out of park with KOEO.
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next