|Prev||Professional Automotive Repair Technical Discussions for March 21, 2010
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|2003 Hyundai Elantra GLS 2.0L c.v joint VIN: KMHDN45D93
customer came in with a broken axle boot,we replaced the rf cv.axle and ps belt and alt. belt.after we did the repair vehicle started making a noise when turn the steering wheel to the left mainly full lock.and only does it if you give it gas weather you going...
Fixes & Summaries for Asian
|2001 Infiniti QX4 3.5L MIL Lamp on VIN: JNRDR07Y11
Thanks to everyone for the quick replies.I followed Seth's advice and installed a dealer coil on #2, no more engine light, I was glad the iridium plugs were not an issue. Sure is nice to have this site to eliminate guesses . Trouble codes: P1320.
|1997 Kia Sportage 2.0L Poor Idle Quality, Hesitation, Surge, Misfire, Poor Fuel Economy, MIL Lamp on VIN: KNDJA7232V
So the problem here ended up being a bad pcm. Your advice helped confirm that. I wasn't getting consistent 5 volts to my injectors, and they would randomly stop getting a pulse signal altogether. My fuel trims were in the negatives all the time, and would go ... Trouble codes: P0300 (Random/Multiple Misfire), P0301, P0302, P0303 (Cylinder 2 Misfire).
|1995 Mazda 626 LX 2.5L Cuts out, Stall VIN: 1YVGE22D6S
thanks for all the help. ended up taking to a trans shop had internal falure
|2000 Nissan Maxima SE 3.0L slave cylinder VIN: JN1CA31D6Y
I wrapped the clutch rubber hoses with a fiberglass heat shield. Also, I removed the slave cylinder, took a flat sheet of fiberglass heat shield and totally wrapped the slave cylinder to shield the heat from the head and coolant hose. This actually worked. ...
|2007 Toyota Highlander Hybrid Limited 3.3L steering VIN: JTEDW21A57
thanks for all responses iwas not able to reset current values with scanner due to vehicle needing a relay for converter this vehicle had to go to dealer however i did learn that my equipment is able to reflash