 Prev |
Professional Automotive Repair Technical Discussions for March 20, 2010 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 1999 Dodge Caravan 3.0L Poor Idle Quality, Hesitation, Surge, Cuts out, Misfire, MIL Lamp on VIN: 2B4FP2530X I have a gem here. Gut says PCM. This van has multiple codes. Has severe misfire even at steady speeds(ALMOST all the time) but occasionally will run smooth at steady cruise. It starts and idles great. Under accel will usually fall flat on its face and as you ... Trouble codes: P0300 (random/multiple cylinder misfire), P0420 (Catalyst Efficiency failure), P0125 (Closed loop temperatrure not reached), P1281 (Engine cold too long), P1695 (No Body bus message), P1698 (No trans bus message) |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2001 Dodge Intrepid SE 2.7L No Start, control pulse 2 coil OK guys, I had been out of the business a couple years and got back into it last spring, of course I was always helping folks while I was out of the field. This one tossed me a curve ball, and the cause was simple. Even though 2 of us double checked the tim... |
6 | |
| 2003 Dodge Ram 1500 SLT 4.7L Blower motor VIN: 1D7HA16N03 thanks for all the help.Turns out yhe problem was an intermittent ground. |
10 | |
| 1996 Plymouth Neon 2.0L transmission VIN: 23G3R42333 I noticed that the fluid had a alot of bubbles in it. the costomet had gotten a used transmission and we put it in and it fixed it. I have a feeling it was a bad pump. |
10 | |
| 1996 Plymouth Grand Voyager LE 3.3L Check Shift signal VIN: 1P4GP44R7T I dropped the valve body and checked the "rooster comb" for damage= none found. Reinstalled the valve body, pan etc, before reinstalling the Park/Neutral Switch and PRNDL switch I pushed in on plungers several times by hand (someone had suggested that they mig... |
3 |
