Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for January 16, 2010
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2002 Dodge Intrepid ES 3.5L steering rack VIN: 2B3HD56M52
Hello,fellow techs I need a some help,advice,or knowledge.This Dodge came in with no power assest at idle or low speeds(It's fine going down the road).It had very little to no return flow on the return line to the reservoir,so I flushed the P/S fluid & put a p...
2006 Dodge Ram 3500 Truck Laramie 5.9L Starting VIN: 3D7MX48C07
Help!!! Can't sleep at night with this one. Vehicle was towed in from another shop. I'm always very careful about throwing stones at another shop, but this came in a mess. ECU, Fuel connectors, batteries all disconnected. Belt missing. The shop told customer i...
1996 Jeep Cherokee Sport 4.0L Hesitation, Misfire VIN: 1J4FJ78S1T
This Jeep came in as a no start. We cranked it over and the cap, wires, etc. looked like the 4th. of July. Arcing all over and it was damp and humid out. We replaced the cap, rotor, wires, plugs with quality parts. The vehicle then started right up. Problem is...
2000 Jeep Grand Cherokee Laredo 4.7L Engine VIN: 1J4GW48N9Y
Vehicle was towed in due to overheat. Diagnosed bad head gasket and lower bearing noise. Installed rebuilt crate longblock for initial diagnosis. Vehicle left with customer running fine. Vehicle came back with SES light on, Code P0304 Cyl 4 misfire. Checked S...

Fixes & Summaries for Chrysler
Fix/Summary Answers
2009 Dodge Grand Caravan C/V 3.3L trans VIN: 1B4GH54R9N
thanks to all aldata listed the two relays i was informed of as cooling system relays so wasnt sure thanks again
1994 Jeep Grand Cherokee Limited 4.0L clutch pedal VIN: 1J4GZ68S3R
This vehicle is fixed! I replaced the clutch master cylinder and bled the hell out of it.The clutch now starts to engage 3-4 inches off the floor which is what I was looking for.Everyone had great suggestions and yes Dan, the crank did move some but did not af...
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next