|Prev||Professional Automotive Repair Technical Discussions for November 15, 2009
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|1998 Honda Accord EX 3.0L MIL Lamp on VIN: 1HGCG1652W
I had a code P0401 on this Honda, pulled the upper intake and cleaned the carbon out of the plugged up lower intake & installed sleeve and upgrade EGR Valve, thought it was a no brainer, 2 weeks later, same code...Does anyone have any advise on what direction ... Trouble codes: P0401
|2003 Honda Odyssey LX 3.5L Mechanical VIN: 5FNRL18573
The transmission was slow to go into drive or reverse when cold, drove normal after warm up. Now it has died and we found codes P0740 & P0700 & 40-01. I believe the transmission is worn out as is common on these Honda automatics. We are recommending a Honda re...
|1990 Toyota 4Runner SR5 3.0L cruise control VIN: JT3VN39WXL
cruise control doesnt work, blinks 5 times and records code 12, found powers and grounds okay. clutch switch, brake switch, e-brake switch are working as designed. found no test for the ecu and all the post i have found say that it is rare to replace the cruis...
|1999 Toyota Tacoma SR5 3.4L No Start, Poor Idle Quality, MIL Lamp on VIN: 4TAWN72N7X
Hello to all. Need a little help to step in the right direction. I have this tacoma that im working on for a friend on the side. He originally called me with a running rough complaint and a check engine light on for an intake air temp sensor. When he went to s...
Fixes & Summaries for Asian
|2006 Honda Civic DX 1.8L dash lite VIN: 2HGFG11876
well,fixed car but had to find scanner to communicate with vechicle,couldn't use dash lite to get codes.pretensioner &crash sensor bad
|2006 Toyota RAV4 2.4L no start at times VIN: JTMZD31V66
It's been 3 wks since we gave it back to the customer, so we'll close with a fix. When it would't start, we had no injector pulse, or spark! We spent much time tracing a 3.5v feed, to the "non power side"(Term #5) of the Ign2 Relay. That terminal should only...