|
|
2008 Chrysler 300 (Car) 2.7L air bag light on
We have replace air bag module, both drive and passenger
air bags, impact sensors,seat belts. and still getting an
air bag light on. Wanted to know if their is a self test
system that will produce codes. |
View |
|
2002 Dodge Durango 4.7L no pcm response
R/R a 4.7 motor, intallition went good, all connections
accounted for, no response from pcm, no start, no injector
pulse, tested out possibilities.
Will a Jtec motor work with a NGC computer? I have a NGC
computer, motor that came in was a jtec |
View |
|
2005 Dodge Ram 3500 Truck 5.9L Hesitation, Cuts out
Ok I need a little insight on this one. Diesels are not my
strong point. Good customer I would like to help them out
if possible. Truck was in a month back with the same codes.
Truck had no throttle response at times. I replaced the TPS
and cleared the codes t... Trouble codes: p0341 (CMP signal error), p0652 (sensor reference voltage B circuit low), p2127 (Throttle validation switch low), p0069 (Boost key on rationality). |
View |
|
2002 Jeep Grand Cherokee 4.0L Accessories
After removing dash and repairing broken mode doors in
heater box now customer states heated seats no longer work.
Checked seats and found no operation at all with ether
seats heated seat switchs do light up when turned on.
Checked all connections including bc... |
View |
|
2007 Chrysler PT Cruiser 2.4L right turn signals
Thanks to all for the help. As per suggestions I have narrowed this down to the multi function switch which has power supplied to it but none out on the turn signal circuit. Am only waiting for the customer to purchase switch from the dealer and install. Than... |
11 |
|
2001 Dodge Grand Caravan 3.3L power sliding
Most of the replies were to check the track wiring harness as I already had done. The was no power from the module to the door motor. Both door motor circuits latched ground when activated. I replaced the PSD module and the door now operates properly. Thanks t... |
7 |
|
Prev
