|Prev||Professional Automotive Repair Technical Discussions for August 2, 2009
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|2003 Nissan Altima S 2.5L Cuts out, Stall, MIL Lamp on VIN: 1N4AL11E23
hi all and thanks in advance for your help. about 10 months ago vehicle came in for a p0335 crankshaft sensor and a engine speed code for the transmission (I don't remember the code number). I replaced the crank position sensor and the cam position sensor (cam... Trouble codes: P0335 (crankshaft position sensor)
Fixes & Summaries for Asian
|1996 Honda Prelude Si 2.3L Hesitation VIN: JHMBB2155T
lab scoped t.p.s. till i almost went "blind" KENT [...], calif, thanks, i went there first, they were o.k. DAVID & MICHAEL, calif, TIM penn., BINGO, front o2 would go into fuel control, closed loop, sometimes, if it felt like it. slower than slow and lazy. new den...
|1993 Mitsubishi 3000GT 3.0L engine VIN: JA3EM64J6P
As one of the tech. requested we checked the crankshaft ring that passes through the crankshaft sensor and it was not in align with the cranshaft pulley. We pulled off crank pulley and found that the pins were sheared off, so we drilled out old pins aligned th...
|2002 Toyota Highlander 3.0L No Start, Poor Idle Quality, Cuts out VIN: JTEHF21A02
WIRING TO ECM WAS SHORTING OUT AT THE FIREWALL CONNECTOR. AFTER REPAIR VEHICLE RUN AND STAYED RUNNING ON OWN BUT WE REPLACED THE TIMING BELT SINCE IT WAS NEVER DONE. VEHICLE RUNS FINE NOW