|Prev||Professional Automotive Repair Technical Discussions for July 26, 2009
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1998 Ford Windstar GL 3.8L overdrive VIN: 1F4ANJUUEG
hi all and thank you in advance for any help. i need advice on this 98 windstar with a code po734, incorrect 4th gear ratio. the trans shifts fine in all gears including od when cold but once it warms up it will not go into od. it stays and pulls fine in 3rd g...
|1999 Ford Taurus LX 3.0L MIL Lamp on VIN: AFP53U8XC2
Hello Techs and thanks for taking a look at this. This Taurus is back for the 3rd time for a code P1450. On the first visit the tank was dropped and an actual hard kink was found and repaired in a plastic vac line above the fuel tank. Car went home with MIL ou... Trouble codes: P1450 (Cannot bleed up Evap System)
Fixes & Summaries for Ford
|1998 Ford Mustang GT 4.6L compressor clutch VIN: 1FAFP42X2W
Okay, I don't like to throw in the towel, but on this one I finally did. Some additional information: 1-the clutch air gap was fine, I was not receiving voltage from the CCRM to the clutch. 2-I do not have the ability to see the power steering cutout for the a...
|2001 Ford F-150 King Ranch 5.4L Unknown VIN: 1FTRW07L51
thenks for all the replies, Iatn rocks!! We pinched off all the lines and problem was still there. Took a while to get the abs unit but fixed the problem!!! We noticed some things while we were replacing the unit. First, one of the two rubber caps on the u...