|
1987 Ford Bronco II 2.9L 02 leads
At some point in time the plug for the 02 sensor harness
was cut out of the system, some shop wire nutted the
harness to the 02, the problem i have is the harness plug
is no longer available, the 02 has the typical 2 white and
1 black wires and no longer has a... |
View |
|
1989 Ford Bronco II 2.9L Starting
tHIS VEHICLE HAS A NO START CONDITION(VEHICLE CRANKS).
CUSTOMER CHANGED HIS STARTER AND STARTER SOLENOID AND
REVERSED THE WIRES ON THE SOLENOID AND THAT'S WHEN THE
PROBLEM OCCURED. IT BURNT THE COMPUTER AND WE REPLACED IT,
AND THE VEHICLE RAN GOOD COLD BUT,AFT... |
View |
|
1998 Ford Mustang 4.6L compressor clutch
I am having trouble figuring this one out. The compressor
was replaced due to a broken/overheated clutch assy. My
Solus Pro shows an a/c request and wotCutoff as 'off'. The
wot pid will intermittantly turn 'on' and I get a voltage
increase on my pnk/yel wire f... |
View |
|
2001 Ford ZX2 2.0L high idle
this idle is way to high i have smoked it and no vac leak
found..replaced iac 2 times ,,,coolant temp sensors,,by the
scan data it looks right ...computer is calling for 17
iac... if you unplug iac the idle stays the same 1300rpm i
have checked timing and it i... |
View |
|
2002 Ford Taurus 3.0L Misfire, MIL Lamp on
I appreciate any help!?! I'm stuck on this one. Customer
complained engine was running rough when first started in
morning before work and sometimes when started up after
work to go home. MIL would come on solid (P0302 and P0316).
It would only miss for short ... Trouble codes: P0302 (Misfire 2 cyl.), P0316 (Misfire on start up). |
View |
|
2002 Ford Mustang 3.8L gen module
Hi Guys maybe someone can help me out with this problem. A
car came in with the customer compalint that the battery
goes dead if left 2 days without being started I found a
179 ma draw after pulling fuses I found draw in battery
fuse box maxi fuse #6 looked at... |
View |
|
2003 Ford Windstar 3.8L Hydraulics
Just received a call from one of the techs. He replaced the
leaking rear wheel cylinders only and has tried to bleed
the system according to ALLDATA info. It appears to be a
regular process except he cannot get any of the wheels to
bleed out. The Master cylind... |
View |
|
2003 Ford Excursion 6.0L No Start, Cuts out, Stall
Replaced turbo and #2 fuel injector. Started truck and let
run for 20 minutes until temp came up. Idle smoothed out
and I scanned with snap on modis and a self test. I did a
oil and filter service and checked for leaks. Everything
looked good. I took the truck... |
View |
|
2006 Mercury Mountaineer 4.0L blower fan
hi group,have this 06 mercury,display on control panel,will
show bars low to high all other function seem normal,have
no blower motor operation,fan is good(tested
direct)resistor unit is replacd.do not know how to get
codes from this system,thanks for looking. |
View |
|
2007 Mercury Milan 2.3L Steering
Complaint was left turn, most of time, will hear a noise
that sounded like a power steering hydraulic issue. Nothing
for a Milan nor a Fusion in archives. (Even Googled the
issue, and pretty well came up blank.) One TSB stated "may
exhibit a steering grunt noi... |
View |
Prev
