|Prev||Professional Automotive Repair Technical Discussions for June 20, 2009
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|2006 Mitsubishi Montero Limited 3.8L transmission VIN: JA4MW51R12
35 to 44 mph 1800 to 2000 rpm (5th gear) Hi guys: This SUV has a bad vibration at 4O MPH and 1800 rpm, Going up the hill the condition is at 35 mph and 2000 rpm. I am not very familiar with this type or vehicles. I would be very thankful for any advise i can ...
|1989 Nissan Sentra 1.6L Poor Idle Quality, Stall VIN: JN1GB22SXK
I seemed to be getting the good ones lately. This one is for you import techs. Car was towed in because owner stated that car had key power but no start. Upon arrival I got in and drove the car into the bay. Starts fine and every time but does have a slight ro... Trouble codes: 55 (No problems)
|2000 Toyota Camry CE 2.2L Poor Idle Quality, Stall VIN: JT2BG22K5Y
car came in with locked up motor. replaced with a used motor and can't get it to idel. we have the exhaust disconnected,tryed adding more fuel,replaced all ign. parts, swaped injectors and egr valve. we ran the car without the exhaust manifold and it is ok, so...
Fixes & Summaries for Asian
|2001 Isuzu Rodeo S 2.2L shifting VIN: 4S2CK58D51
THANKS FOR THE RESPONSE. THE PROBLEM CAME OUT TO BE THE ALTERNATOR. NOW THE TRANSMISSION SHIFTS PERFECT.
|1999 Mazda Miata 10th Anniversary 1.8L unrun monitors VIN: JM1NB3537X
Thanks to all that offered help. If I hadn't already tried suggestions given, then I did. Many suggest temp and various running cycles. Nothing worked. Special thanks to Steve @ Gearheads Garage for working with me through this. After 225 miles on the dyno,...
|1999 Mitsubishi Montero Sport LS 3.0L transmission VIN: JA4MT31H0X
ecu appears good inside.using vantage wiring is sound. inputs are good however no signal from output speed sensor. concluded that problem is internal , maybe a problem with the signal generator , trigger wheel.