 Prev |
Professional Automotive Repair Technical Discussions for June 7, 2009 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 2002 Chrysler Town & Country Limited 3.8L Doors This van is equipped for wheel chair access, has automatic doors, factory, and a wheel chair ramp. While the battery was disconnected, I opened the passenger door, manually. Now the door is inop, with buttons or remote. The ramp is set to go down with the door... |
View | |
| 2000 Jeep Grand Cherokee Laredo 4.0L engine VIN: 1J4GW48S6X Thanks in advance - concern is No Start - Confirmed customer concern of cranks but won't start - tried and was unable to communicate from scanner to vehicle PCM - unplugged all 5v referance sensors and was then able to communicate - plugged sensors back in one... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2005 Dodge Ram 1500 ST 4.7L Stall VIN: 1D7HA16NX6 THANK YOU!! for all of the ideas. Turrns out it was a wire harness issue a wire had rubbed through insulation at a point in the harness where there was no black plastic covering from the factory.Finding it was a nightmare but customer has had truck back for 2 ... |
8 | |
| 2007 Dodge Ram 2500 TRX4 5.9L unknown VIN: 3D7KS28C87 I ended up maxing the caster angle to a positive 6.25 degrees and boosting the air pressure up on the d load tires will tell cust needs to buy e load to run propeer air pressure that seemed to fix the death wobble but does still shimmy a little bit, found the ... |
6 |
