|Prev||Professional Automotive Repair Technical Discussions for March 8, 2009
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|2001 Mazda Tribute ES 3.0L MIL Lamp on VIN: 4F2YU0911K
Have a strange problem here...This Mazda ( same thing as a Ford Escape )came in with SES lite on..Code PO401 EGR flow code...checked DPFE valve..found corosion on valve..so replaced it and cleared code...Truck was ok for about 3 weeks..SES lite came back on th... Trouble codes: P00, 401 (po 402-), P00, 402
|2001 Nissan Patrol 3.0L Hesitation, Surge, MIL Lamp on VIN: JN1TESY61A
Car came in with mil light on. Owner suspected he picked up some bad diesel, removed and cleaned out tanks and replace fuel filter, reset fault codes and road tested. Light cam straight back with p7 fuel injection feedback. Have no info on this vehicle. Any id... Trouble codes: 77 (p7 fuel injection feedback)
|2003 Nissan Xterra SE 3.3L evap p1490 VIN: 5N1ED28Y63
Hello Friends, I have a 2003 X-Terra that seems to be broken although our testing shows all is well. The vehicle is in good condition. There are no signs of modification or previous collision damage. Because the vehicle failed IL EPA OBD2 emissions testing, ... Trouble codes: P1490 (Vacuum cut valve bypass valve circuit wrong voltage)
Fixes & Summaries for Asian
|1997 Honda Civic EX 1.6L Poor Idle Quality, Surge VIN: 1HGEJ8643V
We havent fixed this one yet. The customer left it with us and is in no hurry. We are going to get it in again this week. We have checked the marks on the cam and crank and they are lined up correct. We checked the timing before we went home and it was about 2...
|2003 Kia Optima SE 2.7L Stall VIN: KNAGD12311
thanx for all the replies, this one turned out to be a bad main relay, i finnally got the car to act up most of the time and when it wouldnt start there was only 5 volts to the crank sensor and 12 volts when it would start!!! i think part of the problem came f... Trouble codes: P0335, P0741.
|2005 Mazda 3 S 2.3L No Start VIN: JM1BK32365
Thanks to Allen,Jason, and Mark. I've delayed closing this post to see if the car stayed away,and it has. This was a crank pulley "positioning" problem,the valve timing was never disturbed.After re-installing the pulley, the engine would run, very poorly, o...
|2002 Mitsubishi Montero Limited 3.5L Stall VIN: JA4MW51R6J
This one really stumped me, I wish I had some great diagnostic story here but i dont. This is how the diagnosis went down, I was going through all the steps one would normally go through when a coworker came up to offer his advice,all the while laying his ha...