× Auto Repair Pros Member Benefits TechHelp Knowledge Base Forums Resources My iATN Marketplace Chat Pricing About Us Join Industry Sponsors Video Members Only Repair Shops Auto Pro Careers Auto Pro Reviews
Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for March 1, 2009
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Asian
Help Request Answers
2005 Honda CR-V SE 2.4L Readiness Code VIN: JHLRD78905
Monitor and readiness code question. Vehicle came in with dead battery. We replace the battery and checked the starting and charging system (no problems found). No power to the system clears MIL codes and resets the readiness code. I have checked for trouble c...
View
2002 Mitsubishi Diamante ES 3.5L abs module VIN: 6MMAP67932
Completed test of the on the car abs system: power, grounds, reference signals etc: ok No pump operation. Customer brought in a used module/pump. Can this be tested off the vehicle by supplying power to the module to verify pump operation before installation?
View

Fixes & Summaries for Asian
Fix/Summary Answers
2000 Isuzu Trooper Limited 3.5L 4wd VIN: JACDJ58X1Y
Isuzu is fixed. even with the lack of responses, I forged forward. I determined that the vehicle had to be driven above 25 mph for 50 ft or so to set a code in the TOD, and shut off ABS. I pulled code for the front axle position switch. determined it was open,...
3
2002 Kia Rio 1.5L Cuts out, Stall VIN: KNADC12322
i apologize for the late return message. i also want to thank all who sent in suggestions. we tried all that we received, but after trying each one we would run the car and found the problem still there. last week cleaned the maf as a last resort. the car star...
7
1996 Nissan Maxima GLE 3.0L state inspection VIN: JN1CA21D8T
The maxima finally did run the o2 moniter The Bosch o2 sensor was fine Took about 75 miles of driving over 3 days both cold and hot starts Got car inspected All is well As for the P0325 knock sensor code that was not turning on the CE light, it is still in co...
15
1999 Nissan Maxima GLE 3.0L injector pulse VIN: JN1CA21D3X
Hello everyone: thanks to all replies this is a fix. Many of the replies pointed to crank sensors. There is one on front of engine POS and another on the transmission REF for flywheel reference. The one on the transmission side can cause this sympton. A no sta...
12
1995 Toyota Avalon XL 3.0L neutral in all gears VIN: 1995TOYAVA
WELL THANKS TO ALL FOR YOUR HELP I'M FINDING THAT THIS CAR HAS A BAD TRANSMISSION COMPUTER AND THATS THE REASON ITS IN NEUTRAL ALL THE TIME THANK YOU FOR ALL YOUR HELP
7
1996 Toyota RAV4 2.0L Unknown VIN: JT3HP10V3T
Thanks to all who replied! A good number of the suggestions were to take a look at the engine running temp. Apparently the PCM will delay a shift into the high gear until the engine is at normal operating temperature. I asked the customer if the car took a lo...
7
1998 Toyota Corolla CE 1.8L Power Window VIN: 1NXBR18E1W
Wow!! Overwhelming Response! Thanks to all who took the time out of their busy lives. The window is fixed. I took Peter from Georgia's advice and applied 12v direct to motor and window would not go up. Well, I learned right there that the motor was bad (just a...
18
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next