|Prev||Professional Automotive Repair Technical Discussions for February 7, 2009
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1996 Mercury Cougar XR-7 4.6L fluid pressure VIN: 1MELM62W8T
hello everyone- this cougar had the rack replaced last year due to worn tie rods and end seal seepage-old age. last month car dropped off at garage with return hose off metal fitting at rack.very cold or possible tech had not secured clamps properly? due to ru...
Fixes & Summaries for Ford
|1995 Ford Thunderbird LX 4.6L Stall VIN: 1FALP62W6S
I personally replied to all who helped and to the rest of you following the post: the car had a shorted wire between the ECM and the ECT that caused the intake air temp to differ from the coolant temp after the car went through a cold soak. Thanks again
|1996 Ford Aspire 1.3L oil leaks VIN: KNJLTO5HIT
O.K. guy,s here it goes..have I truly fixed vehicle? we,ll see..totally no obsolete parts avail..thus i can-not repl,or-re-seal oil pump to block..at this time..two x-cellent replies!! however!!!1 seal all crankcase ports,,apply 3-4 psi to dipstick,tube..x-cel...
|2003 Ford Expedition XLT 4.6L reverse lights VIN: 1FMRU15W03
Finally found it!! I pulled a very lame brained stunt along the way, though. I installed a higher amp fuse in place of the 10 and managed to blow a line in the CJB circuit board. I had to pull the box apart and solder in a bridge. That was fun. I also ...
|1991 Mercury Grand Marquis GS 5.0L Warning chime
A few had said the seatbelt,door,etc. chime, relating to their prospective switches.The chime we heard had a totally differant ringtone.Most had said that this was a backup alarm in the AIR BAG system. With the AIRBAG light out, this sounded as a reminder to t...
|2007 Mercury Milan 2.3L No Start, MIL Lamp on VIN: 3MEHM07Z07
This vehicle did indeed have an issue with the key, this i already know when I posted for help. I was mainly interested in whether there was a relearn procedure available without specific equipment. Thanks to those that replied, I had customer bring down ano...