Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for January 11, 2009
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1997 Ford F-150 Lariat 4.6L rear shoes VIN: 1FTDX1767V
Hi, I have a problem with the correct shoe on this vehicle.Have tryed differet shoes, but pin for sping for lever in wrong spot.This causes adjuster lever to far forward past the adjusting wheel. Has anyone had this problem?This was suppose to be standard rear...

Fixes & Summaries for Ford
Fix/Summary Answers
2004 Ford F-250 Super Duty XL 5.4L Mechanical VIN: 1LTNW21L14
I want to thanks all the techs for help and info.But the only fix for the really tight dipstick tube was to drop the oil pan and tap the dipstick tube from the bottom side. Thanks again!!
2005 Ford Freestar S 3.9L Cuts out, Stall VIN: 2FMZA50605
Thank you for your time The fix was a bad fuel rail pressure sensor, I suspected this all along but I just could not fathom how the p.c.m. could take a piece of bad data and adjust pump speed so low as to cause a serious running and stalling problem. I recei... Trouble codes: P0193, P0191.
2005 Ford F-250 Super Duty King Ranch 6.0L shifting VIN: 1FTSW21P45
the problem with this trans, was a major internal damage, the reverse pack clip came out of place, causing severe damage to all components to the reverse planets, sunshell, and related components, It also damage the case, there is a tsb related to this failure...
2006 Ford Freestyle Limited 3.0L Heated Seats VIN: 1FMZK06166
I would like to thank you all for the help. I have a good direction to go, and will take that path when the customer can bring the vehicle back in. Will post fix when i find the problem. Thanks
2000 Lincoln LS 3.9L Trans vent VIN: 1LNHM87AXY
This unit (5r55n) would loose fluid out the vent codes. We set the fluid level at 180F and allowed the standpipe to drip for 10min at this temp. During this procedure the unit did cool to about 160F. The factory calls for fluid level to be set in the...
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next