|Prev||Professional Automotive Repair Technical Discussions for December 14, 2008
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2001 Chrysler Concorde LX 3.2L MIL Lamp on VIN: 2C3HD46R91
I just had a quick question. I have this 2001 chrysler concorde. P0601 code for PCM failure. I am going to replace the PCM. However i have a question. Does the car have to be sent to the dealer or can a used PCM function fine in this car? Please advise. Trouble codes: P0601
|1995 Dodge Neon 2.0L No Start, Poor Idle Quality, Cuts out, MIL Lamp on VIN: 3P3ES47C9S
vehicle came in with no run situation, have been able to get running with changeing spark plugs with original ones showing severe carbon fouling indicating a rich condition. vehicle will run intermittently but on occasion not able to rev up. all other basics h... Trouble codes: P0107, P0108, P0121, P0122, P0123
|2005 Dodge Sprinter 2500 2.7L MIL Lamp on VIN: WD2PD74455
I need help with this van bad. First off the van went to the dealer for a SRS light on. The dealer said the check engine light was on to. They had said it had codes for #2 cylinder glow plug and module code . They replaced the #2 glow plug. They cleared the co... Trouble codes: P0672 (cylinder 2 Glow plug circuit), P0380 (Glow Plug /Heater A Circuit)
Fixes & Summaries for Chrysler
|1993 Dodge Caravan 3.0L Poor Idle Quality, Misfire
I read the clues wrong on this one from the beginning. Along with my own stubborness, this turned into a nightmare. But now it is fixed. When I put the new timing belt on and it ran on the front three cylinders, I concluded that the front dowel pin could not b...
|2004 Dodge Ram 3500 Truck ST 5.9L MIL Lamp on VIN: 3D7MU4BC54
Thanks for all the replies. I finally got this vehicle back to take a look at it. Robert from Pennsylvania was right. After taking the intake ducting off, you could see where the ground wire had rubbed through the solenoid wires - they were covered in the gree... Trouble codes: P0243 (Wastegate solenoid circuit).