|Prev||Professional Automotive Repair Technical Discussions for November 22, 2008
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1998 Dodge B1500 5.2L no data VIN: 2B6HB1144W
This van came in for tune-up and PM and running poorly. When checking for codes, found none and data on MODIS shows n/a for all sensors and data. I have never seen this before. Anyone got any ideas? Tried MODIS on another vehicle and it is working correctly. H...
|2001 Dodge Dakota 3.9L blower motor VIN: 1B7FL26X41
I need some info from dodge guru's. this blower motor is inoperative, if I supply a ground it will work only on high, and controls will not affect it. I have no schematics, nor do I have any experience with dodge wiring. I did check all the grounds that I can ...
|2002 Dodge Stratus SE 2.4L vehicle heater VIN: 1B3EL46X32
Hello all, Sometimes we get the strangest problems and just don't know where to turn. Well, this is one of them. It's getting cold here in the Northeast and so goes the related problems. This vehicle has a definite problem with the heating system. It's not ATC...
|2003 Dodge Ram 2500 Van 5.2L charging VIN: 2D7JB21Y63
Hi all I have a 2003 dodge ram van driving me nuts 5.2 l 318 no power windows or locks it started with a dead battery so I replaced it then customer complained everytime the a/c is on the charge light comes on and he can see the voltage gauge start dropping .S...
Fixes & Summaries for Chrysler
|2004 Dodge Neon SXT 2.0L Stall VIN: 1B3ES56CX4
guys, thanks for all the replies! i did find a problem with the battery positive cable. it had swells in it near the pdc. i cut open the harness there and found corrision had gotton at the cable. so i ordered and installed a new cable assy, which included a ne...
|2005 Dodge Neon SXT 2.0L Rack and pinion VIN: 1B3ES56C65
Replaced crush sleeve. When column was disconnected, disconnected tie rod ends as well. Binding is inside the rack. What a scary thing! It seems to work ok, but i am taking no chances. I guess a better way to accurately measure this would be to see how much h...