|Prev||Professional Automotive Repair Technical Discussions for September 7, 2008
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1997 Dodge Ram 2500 Truck 5.9L dash lights and engine VIN: 3B7KF23D8V
Intermittently, when the key is turned off the idiot lights and motor stay on - is not the ignition switch. When this happens on the auto shut down relay, circuit #86, ignition switch output (light green with black wire) has 12 volts. Have tried new ignition...
|2000 Dodge Caravan 3.3L No Start, Cuts out, Stall, MIL Lamp on VIN: 1CKIRJUHTY
Ok Dodge masters, this minivan is stumping me... Customer says check engine light is on and vehicle keeps cutting out and is very hard to restart (very long cranking before starting)... Vehicle arrives with a MAP sensor fault that comes right back after cleari...
|2004 Dodge Ram 2500 Truck ST 5.9L No Start, Poor Idle Quality VIN: 3D7KU28C34
Hi to all i am a first time IATN user! We have in a 2004 dodge ram 2500 diesel. The main issue is NO START reguardless of outside temps, however it will start with ether. Although when it does start it runs poorly, engine idles around 1,500-1,800 rpm and misse...
|2000 Jeep Cherokee Limited 4.0L No Start VIN: 1J4FF68S9Y
This jeep has no power going to the injectors and no signal from the driver to fire them. All of the fuses are ok. Although I can't get any info. on which fuses are which . My Mitchell info says the fuse number but they aren't numbered on the car so I checked ...
Fixes & Summaries for Chrysler
|1990 Dodge Dakota 3.9L Poor Idle Quality, Hesitation, Surge VIN: 1B7FL29XXL
This vehicle has been gone for over a week so I will call this fixed. I did learn that the computer does ignore the o2 at idle and reading 0.0 mv is normal. I did see this on another old Dodge that we had in the shop and this was also mentioned by other member...
|1998 Dodge Grand Caravan SE 3.3L all gauges VIN: 2B4GP44G7W
Thank you to all that replied. The problem was cracked solder connections at the harness pins on the instrument cluster circuit board. Many of you told me to check this. I had to use a magnifying glass to see it. I resoldered all pins and put cluster back in v...
|2001 Jeep Grand Cherokee Limited 4.7L Cuts out VIN: 1J4GW58N71
Thank you all for your responses, all suggestions were great and I thank you. TPS, fuel, crank and cam sensors (dealer items) have been checked and tested previously. I was falsely informed that a used PCM could be used to test after reflash, this is not so. O...