|Prev||Professional Automotive Repair Technical Discussions for August 23, 2008
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1997 Chrysler Sebring JXi 2.5L Hesitation VIN: 3C3EL55H5V
When you accelerate this car, it has a severe hesitation or sluggishness. The harder you accel, the worse the condition seems to be. It idles ok and once you get up to speed, it's not too bad, unless you accel again. Customer says the problem came on all at on...
|2001 Dodge Durango 4.7L control head VIN: 1B4HR28NX1
long story. another local shop replaced compressor. sent to us with inadequate cooling. vent temp. at idle was 68 deg. o/side temp. low 90's, 60 deg. @ 1500 rpm. noticed rec. door in fresh air position with control panel in max pos. , proped door open, vent te...
Fixes & Summaries for Chrysler
|1994 Dodge B250 3.9L MIL Lamp on VIN: 2B6H821XXR
First off I would like to thank all who took the time to read my post and them think out the problem. Only 2 seemed to have direct knowledge of this set up. At any rate I found the sensor under the harness that passes from left to right across the front of th... Trouble codes: 22 (Temp. sensor volts to high).
|2004 Dodge Durango Limited 5.7L engine VIN: 1D4HD58D54
The fix was a new radiator. The radiator was restricted. This appears to be a common issue with this Durango. A week later I had another with the same problem. He wasn't so lucky, because he blew his head gasket in the process of going from shop to shop changi...
|2005 Dodge Durango SLT 4.7L Engine VIN: 1D4HB48N55
Thanks for the help guys. This one was fixed by replacing the cracked flexplate, was cracked between the bolts near the crankshaft.