|
|
1999 Chrysler Sebring 2.5L Poor Idle Quality, Surge, Cuts out
Customer brought the vehicle in for running rough and
stall condition. Had original timing belt, replaced belt.
Started vehicle still ran rough. Remove intake and take
acompression test along with a cylinder leakage test. #1
hole was AFU'd 90% leakage. Belt va... |
View |
|
2001 Chrysler PT Cruiser 2.4L shuts off
Hello fellow techs. This car was brought to the shop with
a broken timing belt. A fellow tech at the shop had the
original head refinished and pressure checked and replaced
the motor with a used one from a 98 PT Cruiser. After he
finished the job the car would... |
View |
|
2002 Chrysler Town & Country (Van) 3.8L misc systems
Vehicle was brought in by customer complaining that the
wipers, headlights, and washers come on, and the dash
gauges fluctuate after the key is out of ignition. Stated
that they had found the vehicle doing these things twice,
and that they stopped after the ke... |
View |
|
2002 Chrysler Town & Country (Van) 3.3L posiible evaporator core
Hey guys, got an 02 town and country 3.3L with a front A/C
problem. The vehicle came in claimig to have an a/c leak
and that another shop had died the system. Checked but
could not find any dye anywhere and the system was a little
low. I evacuated and recharge... |
View |
|
2001 Dodge Ram 2500 Van 5.2L No Start
Truck was towed in with a No Start.I check for fuel 48 psi
at shrade valve,No spark at coil. Truck ran fine when
parked next morning would not start.I hear a buzzing from
relay in fuse pannel on side of dash also ASD relay in
distrabution center under hood is ... |
View |
|
2002 Dodge Ram 1500 Truck 5.9L Rack
This truck keeps blowing the seals and leaks fluid from the
tie rod boots.It has A 1.5 inch lift kit in it.This truck
has had by other shops 6 Racks and 2 pumps installed. The
power steering is not working hard until you turn the
steering wheel and then you ca... |
View |
|
2004 Dodge Sprinter 2500 2.7L no power
I need pin out values for the 4 wire MAF sensor; I don't
have a diagram that fits this particular Sprinter. My
readings with key on, plug disconnected: pin #1 yel/red,
12v; #2 brn/violet, ground; #3 yel/blu, 5v; #4 yel/grn, 5v.
With the engine running pins #3 ... Trouble codes: 2355-002 (EGR flow too low). |
View |
|
2001 Jeep Grand Cherokee 4.0L 1-2 shift
thanks in advance for any help, o.d. shift light comes on,
trans shifts out of o.d. shortly after that a.t. overtemp
light comes on. removed pan, and found a little metal, but
not much. does anyone know what the cooler flow rate is, im
thinking the trans coole... |
View |
|
1996 Chrysler Concorde 3.3L Coolant
Radiator cap & thermostat fixed this one.
As mentioned before the cap tested good and was fairly new but just barely passed and when compared to a new one it was obvious the spring was more weak. I removed the thermostat and could see Gaul marks from it dra... |
6 |
|
2001 Dodge Stratus 2.4L Compressor?
Well, seeing that this problem occurs only when it gets extremely hot outside we are having a hard time scheduling the customer in and leaving it with us to duplicate the problem. This system is unique as it I believe to be a Mitsubishi system not a chrysler. ... |
7 |
|
2003 Dodge Stratus 2.4L No Start
Did not fix it the customer was a little impatient, we had it for for four days after the shadetree had it for several months. I did check the p/n on the head and it was not correct, so the shadetree screwed me. Let a real tech check it first and you will ... Trouble codes: P0016 (camcrank out of synch). |
4 |
|
1995 Jeep Cherokee 4.0L No Start, MIL Lamp on
Thanks for your help. Anibal and Randy were right. It was the used PCM I installed. Another used PCM fixed the problem.
I was puzzled. The faulty used PCM tested good in another Cherokee??? |
13 |
|
2002 Jeep Grand Cherokee 4.7L Misfire
turns out the injector is shutting down, no grd from pcm, shut it off and its fine untill i load it a little bit and it comes right back ill dig some more... Trouble codes: 351 (ign pri1cyl). |
19 |
|
2002 Jeep Liberty 3.7L Head lights and wiper blades
Well I had replaced the BCM initially. I had my parts guys make sure the old unit numbers crossed over to a new one. The guys at the local Dodge dealership after a few days of consternation were convinced I received the incorrect BCM and fuse box. They order... |
5 |
|
Prev
