Prev iATN Members TechHelp for July 7, 2008
Automotive Technical Exchange for the Automotive Repair Professional		 Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1999 Chrysler 300M 3.5L No Start
this vehicle drove in to pick up another vehicle.cust. tried to leave and eng. started and stalled several times before it became a no crank.the codes listed would normally lead me to check for ser. buss comm. possible body control issues.it also has a remote ...		 View
2001 Chrysler PT Cruiser 2.4L shuts off
Hello fellow techs. This car was brought to the shop with a broken timing belt. A fellow tech at the shop had the original head refinished and pressure checked and replaced the motor with a used one from a 98 PT Cruiser. After he finished the job the car would...		 View
1998 Dodge Neon 2.0L No Start
This vehicle was towed in to our shop from another repair shop, the complaint is it wil not start. They installed cam and crank sensor before bringing to us, but still no start. We have done testing and have found there is no spark, no injector pulse, no comun...		 View
2000 Dodge Dakota 4.7L MIL Lamp on
Hello Mopar guys, tell me what the deal is with the crank and cam sensors on the 4.7's. I hear there is an issue with them, but I was suprised to not see any cases like mine in the fix database. Code P0320 set (85 start-up cycles ago). Cust. complains of a "ch... Trouble codes: P0320 (no crank sensor ref. at pcm).		 View
2004 Dodge Sprinter 2.7L no power
I need pin out values for the 4 wire MAF sensor; I don't have a diagram that fits this particular Sprinter. My readings with key on, plug disconnected: pin #1 yel/red, 12v; #2 brn/violet, ground; #3 yel/blu, 5v; #4 yel/grn, 5v. With the engine running pins #3 ... Trouble codes: 2355-002 (EGR flow too low).		 View
2005 Dodge Dakota 3.7L engine
Customer brought the truck to me and said it had started to make noise just that day. After listening to it I suggested doing an oil change because the truck was overdue for one and the noise sounded as though it might be a lifter ( the oil was not low). Chang...		 View
1997 Jeep Cherokee 4.0L Cuts out
Jeep feels like its running out of fuel. It bucks badly only when hot and only in drive. Runs fine in reverse. Only under load. NO CODES. FUEL PRESSURE IS GOOD. Checked MAP, TPS, and replaced crank sensor. Checked all grounds and pwr to PCM along with 5v ref a...		 View
1998 Plymouth Neon 2.0L No Start
We got the car and started tracing the wiring. The fuel pump was connected on the wrong circuit in the under hood PBD. What we have found is that the #21 fuse blows when key is turned on. That fuse feeds the ASD, Fuel Pump, DLC and the PCM. The red and white w...		 View

Fixes & Summaries for Chrysler
Fix/Summary Answers
2001 Chrysler Town & Country 3.3L air bag
The problem was that the air bag warning light was on. My scan tool would only communicate with the PCM. The general advice was to disconnect modules one at a time until the faulty one was removed and that would allow the others to come on line. A fault with...		 6
2000 Dodge Caravan 3.0L Poor Idle Quality
I have recieved lots of good useful advise, however this problem is still there. i have to close it due to the rules of iatn but it is just sitting here waiting for the customer to pick it up or me get an idea of some sort that fixes it. thanks for all that ...		 16
2000 Dodge Ram Van 5.9L MIL Lamp on, No communication
Well we called in a mobile auto daignostic guy who had a DRB 3 and he got the same thing. Not much help there, he wanted me to send this van to dealer. To make a long story short we found the SCI wires (PCM Connector #3 Pins 27 and 29) are shorted in the wi...		 8
2007 Dodge Pickup 5.9L Poor Idle Quality, Misfire
I received alot of help on this. I am waiting for the cust. to come back. I was waiting for the compression tool, which I now have. Cust. took another trip with it, I will update when he comes in. Thanks for all the help, and sorry for the late posting!		 6
1998 Jeep Grand Cherokee 4.0L No Start, Hesitation, Cuts out, Stall
SORRY FOR THE DELAY IN POSTING FIX. CUSTOMER JUST RETURNED TO SHOP & HAS NO OTHER PROBLEMS. THE FINAL FIX WAS THE PCM. THE COIL DRIVER WOULD DROP OUT INTERMITTENLY. THANKS TO EVERY ONE WHO HELPED WITH THIS REPAIR!! Trouble codes: P0351 (ignition coil 1 primary circuit).		 6
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next