Prev iATN Members TechHelp for July 1, 2008
Automotive Technical Exchange for the Automotive Repair Professional		 Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1988 Chrysler Conquest 2.6L No Start
Has anyone had a similar situation? Vehicle has good ignitor, ignition module, coil, coil resistor & electronic spark control computer has signal voltage going to the ignition module. There is no spark and the fuel injectors do not open.		 View
2000 Chrysler 300M 3.5L Hesitation
this car will bog down on accel. falls flat on its face.fuel pressure good,tps and map ok.checked timming marks there right on.sometimes it is also hard to start.checked fuel for water its ok.please need help with this one thank you		 View
2004 Chrysler PT Cruiser 2.4L fan motor
Had a similar issue on another PTCruiser in the past that needed a fan motor. Got lucky with a guess last time, would like to be sure this time. When we tested for power there was no power to the fan. Note freon was removed, Key was on and a/c was on. My quest...		 View
1996 Dodge Avenger 2.5L Misfire
Long post thanks for reading. When the vehicle would get hot and customer tried to restart the car would not start until waiting 20-30 minutes to cool off. Found the spark plug tubes filled with oil so I replaced the valve cover gaskets, tube seals, spark pl...		 View
1997 Dodge Pickup 5.9L power steering
On this truck the power steering and hydro boost assist degraded slowly over about a year, untill it completly quit. A third party rebuilt the pump and installed it, but that did not change anything. That is when my friend asked me for help on this truck. We d...		 View
1999 Dodge Pickup 5.9L condenser
The a/c works fine sometimes but will get too hot at idle due to the fan not moving the air properly. I tried replacing the fan clutch with no difference. This sounds strange but the air on the right side of the fan shroud actually has air PUSHING out around t...		 View
2000 Dodge Intrepid 3.5L cooling system
Hi, looking on some insight regarding the cooling system on this car. Car came on the hook for no start, we foud 18 valves bent, previous to this someone had installed timig belt and water pump. Car had severey cloged cooling system - stop leak from the looks ...		 View
2002 Dodge Durango 4.7L No Start, MIL Lamp on
Hey guys, This one is kicking me pretty hard. I swaped the 4.7 engine out with a reman. engine from a very good source. Now the thing will not start, It spins over but no start. Every now and then after spinning it over it will try to start but it acts like it... Trouble codes: P1391 (Manufacturer Control Ignition System Or Misfire).		 View
2004 Dodge Durango 5.7L No Start, Stall
Vehicle intermittently stalls after start up,will not restart unless you cycle the key. If you try to start from the run position it will not start cycle the key and fires up first try. I have no codes stored or pending, everything appears to be within spec.		 View
2005 Dodge Durango 4.7L Battery
Hi everyone thanks for everything in advance. I have this 2005 dodge Durango the battery goes dead if it sits over night.i ckeked the battery for drains and is 600 ma if i unpluged the fuse No 27 wich is the power source to cluster and mudule integrated power...		 View
1999 Jeep Cherokee 4.0L Poor Idle Quality
this jeep will idle fine till it goes into closed loop, then it runs like a hesitation, and every 5 seconds it will have a quick jump in rpm and go back down in a snap,once in a while it is doing the jump, fuel system will jump from closed loop to OL/drive on ...		 View

Fixes & Summaries for Chrysler
Fix/Summary Answers
2003 Chrysler Sebring 2.4L locks, radio, interior light
Pretty much everyone was correct. The IOD fuse was blown. It was just hard to see. The customer then told me that someone had tried to jump start her car and reversed the leads. Thanks for all the replies. 		8
2002 Dodge Intrepid 2.7L No Start
thanks fellow tech for all your help after engine tear down it was deterimed that engine had excessive sluge bildup causing chain to jump time replace chain and gears vechile started thanks again fellow tech it is good to know their is help out there when need...		 8
2003 Dodge Pickup 4.7L condenser fan
Although the fuse checked good the wire connection under the fuse was burned. It made a little contact but wouldn't carry any load at all. Some replies were helpful suggesting an updated fan motor and harness, but the customer opted to repair the wiring and ...		 10
2004 Dodge Durango 4.7L all
Well the fix is in. Dodge put a torque converter,front pump, and a modulator in at their expense (they said it would have been 900)(extended warranty) and a filter and some other not warrantied stuff at 250 customers expense but she is back on the road again. ...		 9
1998 Jeep Grand Cherokee 4.0L guages,windows,locks
Ok, finally fixed it. After unpluging almost every modle connected to the bus lines tying to eliminate the ground it was still there. The only module I didn't unplug was the A/C. At this point I was using my power probr to see if the ground was still presen...		 7
2002 Jeep Grand Cherokee 4.7L No Start, no crank
Thanks to Chip and Ron for the help on this one. The fix was replacement of transmission range sensor. Have been waiting for customer to get back from vacation before I closed help request. Talked to them yesterday and all is well, they drove it to Florida and... Trouble codes: P0218 (over heat operation), P0706 (shift postion failure), P1698 (no bus message from pcm).		 2
1987 Plymouth Voyager 3.0L Cuts out, Stall, Misfire
I Went out to VEhicle YESTERDAY MORNING & STARTED CAR SAW GAS COMING OUT OF VAPOR CANISTER PERGE SOLENID THEn CHECKED FUEL PRESSURE REGULATOR VACCUM HOSE CONNECTION & FUEL CAME OUT DEAD GIVE AWAY. REPLACED REGULATOR TODAY RUN PERFECT THANK FOR THE TIPS T...		 4
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next