|
2000 Chrysler 300M 3.5L No Start, MIL Lamp on Car came in on hook, lost power while driving at 55MPH.
Also stated coolant was boiling out of recovery tank? Upon
cranking the engine sounded out of time. I removed the fans
and accessory belts to remove the timing covers and found
the engine in perfect time ... Trouble codes: po340 (no cam ref signal at PCM). |
View |
|
2001 Chrysler 300M 3.5L Cylinder Hey guys, got this 01 300m with an ignition cylinder that
WILL NOT turn. Customer states it is his only key and he
came out of the store with the problem acting up for the
firts time. I believe I need to replace the cylinder,
however, I think it needs to be in... |
View |
|
2001 Chrysler Sebring 2.7L MIL Lamp on I don't know what's going on here. The car came in a while
back with a P0442 and a P0172. The Evap was fixed. the
original tech found a MAP with 1.8v at idle. He swapped in
a new one and voltage dropped to 1.3v at idle.
Now it's back with a P0108 MAP Circuit ... Trouble codes: P0108 (MAP Circuit High Voltage), P0172 (Rich bank 1). |
View |
|
2000 Dodge Pickup 5.9L Low fuel pressure This truck I just installed a rebuilt injector pump because
of a no start and pump failure codes. It ran fine a few
days and now the transfer pump varies in pressure. On first
start up it will be 13psi at idle and will suddenly drop
off to about 3psi. The cust... |
View |
|
2002 Dodge Pickup 5.9L Poor Idle Quality Hello all! Got this dodge with an erractic idle mostly when
cold but will act up sometimes hot or cold. What happens is
after initial start-up, idle's slightly high just over
1200. Slowly idle comes down, but idles up and down between
600-950. We replaced inta... |
View |
|
1987 Jeep Wrangler 4.2L 5th gear My question is will the clearence in the other gear efect
5th gear? the tranny is Peugeot type.I must be missing
something.I have replaced 5th gear once after rebuild.
thanks in advance |
View |
|
2002 Jeep Grand Cherokee 4.0L Hesitation, MIL Lamp on Thank's in advance for your help. We took this vehicle in
about two months ago after both Jeep dealerships in town
told them DON'T COME BACK. Vehicle has been driving around
in limp mode for over 4 years. The pcm was replaced, o2
sensors, oil pressure sensor, ... Trouble codes: P1763 (governor pressure sensor volts to high). |
View |
|
1998 Plymouth Grand Voyager 3.3L No Start Hey folks,
This Grand Voyager is giving me fits. Of course, it's a
relative's vehicle so nothing but problems. Replaced engine
this weekend and everything went extremely smooth so I
should have figured we'd have problems on startup. Problem
is, it won't start... |
View |