Prev iATN Members TechHelp for May 5, 2008
Automotive Technical Exchange for the Automotive Repair Professional
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2000 Chrysler Concorde 2.7L shift indicator ,radio,odometer light
hi techs I had this oo concord here with shift indicator light,radio light, odometer light,over head console light blinking when head light on sometime . the dash and guage light seem to be ok.there is no body code the dash light volt seem ok .I suspecting hea...
View
1995 Dodge Ram 3500 Truck 8.0L Poor Idle Quality, No Power
Hey team, No exact match in the archives that I have found. Not sure if my scanner is leading me off in bad directions. A visual of the injectors found no debris. This truck runs like the cat is plugged. A prior shop cut the exhaust loose to check for rest...
View
1998 Dodge Ram 1500 Truck 5.2L Hesitation
hi techs,this one is pulling my hair out!truck came in with a ruff idle,stall.had a idle air problem.fixed that,but ended up needing a motor also.after installing a used 2001 5.2L engine i have a new problem.while test driving about 2 miles the truck started t...
View
2000 Dodge Ram 2500 Truck 5.9L No Start
This truck was towed in. The engine stalled as if shutting of the ignition. It has not started since. It cranks fine and the transfer pump runs as it should, but it doesn't try to start. Codes P1687 & 1693 were stored. Thanks for any help. I'm not a diesel tec... Trouble codes: P1687 (No cluster bus message.), P1693 (DTC detected in PCM DTC in companion module.).
View
2005 Dodge Dakota 3.7L unknown
customer has complained that after a 30 mile or so drive the a/c will start blowing warm, and then vent flow will stop. he seems sure that the evap. is freezing up. as when he runs the vent he will get no air flow. we cannot duplicate the problem. we have test...
View
2000 Jeep Cherokee 4.0L Mechanical
Thanks in advance. I'm a ford man, but i've got this Jeep that makes a scrubbing noise when the brakes are applied. When I put the chassis ears on it I can tell it is coming from the left front. I've replaced the wheel bearing hub assembly, rotors, and brake p...
View
1998 Plymouth Grand Voyager 3.3L Climate Control, door locks
I fixed a headlight problem (they were non-op) in this vehicle by replacing the BCM. Everything worked for almost a week until the vehicle's battery was drained because of a door being left open. The customer had the vehicle jump started and now, almost all th...
View
1999 Plymouth Neon 2.0L steering
1999 dodge neon. automatic, 2.0 sohc. 14" wheels. (considering trying rack for 15" wheels.) the vehicle has a severe steering problem it came to the shop with a "pull" in the steering, with a vibration and tire wear. (most of these following symptoms were rep...
View

Fixes & Summaries for Chrysler
Fix/Summary Answers
1994 Dodge Caravan 3.0L engine
I am posting this as a fix even though I did not actually repair the van. The majority of you said I needed to replace the computer and wiring harness along with the engine and trans because of the different ignition systems. Since we had the wrecked van we ...
23
2002 Dodge Grand Caravan 3.3L Hesitation, Surge, Cuts out, Stall, Misfire
Hi all, thanks for your responses. One consistent thing that happened with the vehicle was, that although the problem was intermittent, when it did occur it was almost always when the vehicle was placed in reverse. We proceeded on the assumption that we were l... Trouble codes: P0725 (Engine speed sensor), P1684 (Battery power to module disconnected).
3
2002 Dodge Intrepid 2.7L check engine light
Thanks to all that replied. I hope my fix helps anybody else that might have this problem in the future. We stuck to our guns on this one and requested another valve body/solenoid pack from the dealer. We replaced with another valve body/solenoid pack assem...
9
2004 Dodge Intrepid 2.7L low reverse solenoid
we ended up buying an original chrysler solenoid pack, problem solved. thanx guys for your help.
6
2005 Dodge Ram 1500 Truck 5.7L No thottle response
Thanks for the responses Truck was taken back to the dealer - unclear if they reflashed PCM again or just ran the ETC procedure - either way, it now works We had done the following after posting. Per e-mail replies, we borrowed a Modus with the latest software...
3
1999 Jeep Grand Cherokee 4.7L Stall
It was decided that since it so seldom failed to wait until it got worse before continuing on it. Several people thought it was probably the crank sensor. It was suggested that there could be a problem with the ignition switch and one person suggested a shorte... Trouble codes: PP0108 (Map sensor voltage too high).
7
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next