 Prev |
Professional Automotive Repair Technical Discussions for April 26, 2008 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 1997 Chrysler Town & Country LXi 3.8L No Start VIN: 1C4GP64L3V customer brought van in and stated that it will not start after setting in rain. did confirm this and connected scanner and found I could not communicate with body module and the dash is totally dead when this happens. Has anyone seen this before I wish I had ... |
View | |
| 2006 Dodge Ram 3500 ST 5.9L MIL Lamp on VIN: 3D7MX48C56 we checked everthing including cam end play Trouble codes: P0341 |
View | |
| 2003 Jeep Grand Cherokee Limited 4.7L cooling fan VIN: 1J8GX58J53 Replaced compressor with new unit new accumulator new expansion block, evacuate and recharged system.A/C is cooling good pressures low side 40 hi side 220.This vehicle is equiped with a hydraulic fan. It turns when the A/C is turned on,but very slow untill you... |
View | |
| 1998 Plymouth Breeze 2.0L No Start VIN: 1P3EJ46C4W their was a short in cam sensor connecter and crank.repaired wiring.before their was no 5-volt 0r 8 volt supply to sensors and asd relay was not activating.replaced pcm with 1998 stratus from known good vehicle.still no spark but injector only pulses once then... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 2003 Chrysler PT Cruiser GT 2.4L MIL Lamp on VIN: 3C8FY78G13 Whoopeee, it's fixed! It seems that we had weak voltage from the ASD relay that wouldn't allow the fan to operate. I have to say that since it's Saturday and full of distractions from the typical Saturday customers that I didn't spend the time to test and con... Trouble codes: P0480. |
10 | |
| 1997 Plymouth Voyager 2.4L No Communication VIN: 2P4FP25B3V The fix for this vehicle was to replace the PCM. Test results showed that pin #7 of the ALDL had the proper voltage (11 volts)with scanner connected in generic mode, but when looked at with a lab scope there was very little communication (digital square wave)c... |
4 |
