|
2006 Honda Ridgeline 3.5L popping noise
Have popping/creaking/clunking noise on turns, especially
on left hand turns. Can verify on test drive, but unable to
find a loose, worn, or damaged part in front end. Any
suggestions? Thank you in advance. Honda Techs Welcome!!! |
View |
|
2004 Hyundai XG350 3.5L flexplate
Problem is a noise most noticed when cold . I believe it to
be a cracked flexplate. Is this a known problem with these
cars? note: intensity of noise changes from one day to next
. and can come and go when driving. thanks for your help
Don |
View |
|
1993 Isuzu Rodeo 2.6L No Start
first off ,let me tell you that this car has a breathalizer
machine which you have to blow in, in order for the car to
shart, for drunk driving,in state of florida.the
breathalizer is in peremanent lock out ,so every day i have
to get a by-pass code ,to get ac... Trouble codes: 41 (crank angle sensor). |
View |
|
2001 Kia Rio 1.5L engine
Customer had towed from another shop. was having a problem
with internittent overheating. they found coolant leak at
radiator, blown head gasket. they wanted toooooo much to
fix so the customer had us do the repair. we replaced the
head gasket (sent head to ma... |
View |
|
1992 Lexus SC 400 4.0L MIL Lamp on
Not sure where to go on this one. I replaced both O2
sensors because they were weak (would not peak above 700
mv)hoping this would take care of the codes, but it didn't.
The car came is with the complaint that the check engine
light comes on after extended dri... Trouble codes: 21 (Left Main Oxygen Sensor Circuit), 28 (Right Main Oxygen Sensor Circuit). |
View |
|
1999 Lexus LX 470 4.7L Surge
replace timing belt,coolant,oil change. started veh. has
high idle shut vehc. off then restart now surges goes right
into limp mode. Trouble codes: PO120 (tps). |
View |
|
2003 Lexus GX 470 4.7L Cuts out
hello everyone in iatn land,have a this lexus when driving
and you get close to 50 it starts cutting out,thought maybe
cats clogging up gave it a exhaust leak on both banks
inproved a little,so tapped in to fuel line cranking 78 psi
at a idle 42 psi,went and d... |
View |
|
1992 Mazda B2600i 2.6L Hesitation
This truck has a bad hesitation pulling from a stop. It has
been at another garage and they replaced all of the
mentioned parts with no success. What I found was the low
fuel pressure and I have also determined that the pressure
regulator appears to not be wor... |
View |
|
2001 Mazda Millenia 2.5L Poor Idle Quality, Hesitation, Surge, Cuts out, Stall, MIL Lamp on
Hello, I am in need of some help with this Mazda Millenia.
The problem with this car only occurs when it gets hot. The
original complaint was, after driving 15-20 miles the
engine would stumble when you accelerated during a curise.
Customer stated that problem... |
View |
|
1996 Mitsubishi Eclipse 2.4L Poor Idle Quality, Surge, Stall
all right hers my problem, i have a co-worker w/ a 96
eclipse 2.4l. when the car is firts started the idle goes
up to 1300 rmps- and jumps down to 450 rpms sometimes
stalling out. if it doesn't stall out the idle will go into
a lope from 600rpms-[...]. if t... Trouble codes: p0505 (idle air control malfuntion). |
View |
|
1994 Nissan Pickup 2.4L No Start
Thank you in advance for your assistance. This truck will
not start. I have no spark, no injector power,no fuel
pressure, no check engine light when I turn the key on. I
cannot get communication with my Solus scanner. I powered
the fuel pump and it works fine.... |
View |
|
1998 Nissan Frontier 2.4L Readiness monitors
Vehicle failing NC inspection due to readiness monitors not
completing. MIL not on, vehicle is running fine. This is a
first time problem for this vehicle. Customer drove 500+
miles over several weeks. All data is normal, no codes
present. Monitors not complet... |
View |
|
2000 Nissan Altima 2.4L No Start
This one came in for a check engine light and a vibration
at idle. During the test drive the check engine light was
out, the power was good and there was no vibration.
When we hooked the scanner up (OTC Genisys with the Smart
Cable and 2006 Import Software) t... Trouble codes: P0171 (Lean condition). |
View |
|
2000 Nissan Maxima 3.0L abs tcs
this car came in with abs tcs skid and check engine light
on check engine light was for missfire on no2 (repaired)and
code p1211 this code i have no info on.the scanner list it
as tcs c/u function.after clearing it always returns when
starting i have had abs t... |
View |
|
2001 Nissan Pathfinder 3.5L Blower motor
I have a 2001 Pathfinder with a 3.5 litre and auto climate
control that has the blower motor constantly on high.Blower
speed button on control head changes display, but blower
still on high. Shut heater /a/c off , screen goes blank but
blower still running on ... |
View |
|
2002 Nissan Sentra 1.8L Poor Idle Quality, Stall
customer complained of stalling at stop, test drove and at
stop it will idle and then rpm begins to drop off to about
300 rpm then dies. this is an intermittant problem, does it
more when warm, if you give it a touch of throttle it will
not die. it does not cu... |
View |
|
2004 Nissan Titan 5.6L abs
Vehicle came in with an ABS light on. Original DTC was
C1103 (Right front wheel speed sensor). Replace the right
front wheel speed sensor with a original Nissan part.
Cleared trouble codes. Road test and code C1115 came up.
C1115 - Wheel sensor input fault. I ... |
View |
|
2005 Nissan Titan 5.6L u-joint
I have this Triton in the shop with a joint out on the
front shaft. Tried after market, no listing. Checked with
Nisson, they do not sell a joint seperate, only a complete
shaft. This joint has external clips and popped out easily.
We have checked with our dri... |
View |
|
2005 Nissan Frontier 2.5L heater
heater works great at most times. after normal road speeds,
i.e., coming to stoplight, heater cools off. temp gage
reads normal operating temp with no fluctuations during
event. hoses at heater core inlet actually cool off. what i
don't know about is the plast... |
View |
|
1993 Toyota Camry 3.0L rpm's
Hello all. Had a standard R&R/Recondition of transmission
done by local tranny shop I've used for twelve years.
Customer states that since the repair, the rpm's are 500 or
so higher than previously, resulting in percieved engine
wear and definite fuel economy ... |
View |
|
1995 Toyota Corolla 1.8L Stall, MIL Lamp on
Hi Guys, I got this 1995 Corolla with engine light is on &
code 52 in the memo ( knock sensor ) I never seen this
sensor goes bad on toyota, & the problem is car sometimes
dies at idle & some hesitation before the light comes on,
seems like the pcm try to reta... Trouble codes: 52. |
View |
|
1996 Toyota Previa 2.4L MIL Lamp on
Vehicle came to my shop with code p0135, sensor heater had
no resistence,so i replaced sensor and erased codes. two
weeks later vehicle comes back with same code. sensor
heater has 5.54 ohms. my concern is that all data says this
is acceptable in one place but... Trouble codes: P0135 (Bank one sensor one). |
View |
|
1997 Toyota Camry 3.0L 1-2 2-3 shifts
This help request is for Toyota techs I receive this toyota
in our repair shop. The vehicle is not running when comes
to repair shop. We repair the transmission the oil was
burned. We repair the transmission. Before we remove the
transmission i check for dtc. ... |
View |
|
2002 Toyota ECHO 1.5L No Start
Hello Toyota techs, I have this Echo, Echo, Echo, that will
crank, but not start at times. I have been unable to
duplicate this condition. Owner says that it happens often.
She (keyword) also says that she will step on the gas and
it will generally start. Evid... |
View |
|
2003 Toyota Camry 2.4L Misfire, MIL Lamp on
This car came in previously with cyl. #1 misfire. Also, had
codes p0351 thru p0354. Ran through diagnosis for ignition
coil circuit codes without an indication of a problem. F
reeze data tells me misfire is only at cold start. Plugs
are new and coils and wirin... Trouble codes: p0301 (misfire cyl. 1), p0351 (ignition coil a prisec fault), p0352 (ignition coil b prisec fault), p0353 (ignition coil c prisec fault), p0354 (ignition coil d prisec fault). |
View |
Prev
