 Prev |
Professional Automotive Repair Technical Discussions for September 29, 2007 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 2005 Lexus RX330 3.3L roof rack VIN: 2T2HA31U45 At 60 mph and higher there is a rattle from the rear roof area. I found the adjustable roof rack cross bars loose in the locked position and used wood shims to stop any movment in them. No change in the noise. Does anyone have a fix for this? Thanks Tom |
View | |
| 2001 Mazda Tribute ES 3.0L Misfire VIN: 4F2YU09111 This Mazada came in with a complaint of running rough on start up in the morning.Checked system for codes,none found.The custermer said that he wanted the plugs and wires replaced.This system has one coil per cylinder.So we replaced all spark plugs and all fac... |
View | |
| 1992 Nissan Sentra E 1.6L front seal VIN: JN1EB31P3N Hey all: got this little Nissan that came in with a serious leak around the front crank seal. I have never worked on a Nissan, so I went to Alldata. It told me that it takes something like 1.4 hours to replace the seal, but then says it does not include time t... |
View | |
| 2001 Nissan Sentra GXE 1.8L compressor VIN: 3N1CB51D41 Hi all techs : Customer complaint the a/c compressor and the cooling fans came on all the time with the engine running and the a/c switch is off.Car has been maintance well,and no repairs done recently. Here is what i had from the troubleshooting : - unplug ... |
View | |
| 2003 Nissan Xterra SE 3.3L Master Cyl? VIN: 5N1MD28T53 Hello, We have this Nissan that came in with a complaint that the brake all of a sudden started going to the floor. We test drove and was able to duplicate concern. When brake pedal is first pushed it will go to floor. Second push pedal is pretty good. Third p... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 2001 Honda Accord EX 2.3L engine VIN: JN34EY5267 thank you for your help .the problem is the noise from bottom oil pan crankshaft bearing . |
11 | |
| 2001 Hyundai Accent GL 1.5L MIL Lamp on VIN: KMHCG35GO1 Was able to run pressure motor with power probe on used unit that I installed. Re-checked old unit with power probe and it would not run. When clearing code with scanner I could could hear motor click once. With volt meter hokked to power side of motor I had 1... Trouble codes: P1402 (DM-TL over-pressure malifuction detected). |
4 | |
| 2001 Lexus RX300 3.0L abs module VIN: JTJHF01U01 Thanks to all you techs who replied to my techmail. David from KY, Jeff from NM, Phillip from PA, Robert from CA and Rusty from MA. Thanks for all your suggestions. This RX300 drove me crazy. After several tests found ABS/TCS module to be fualty. We installed ... |
6 | |
| 1991 Mazda B2200 2.2L Poor Idle Quality, Hesitation, Stall VIN: JM2UF1134L i would like to thank everyone again for your replies the customer has ordered a carb on line and im waiting for it to arive and install it i think this is going to fix the problem i will try to post answer weather it does or not thanks again |
8 | |
| 2002 Nissan Sentra CA 1.8L Poor Idle Quality, Hesitation VIN: 3N1CB51D42 |
3 |
