 Prev |
Professional Automotive Repair Technical Discussions for September 23, 2007 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Ford
| Help Request | Answers | |
| 1999 Ford Explorer Eddie Bauer 4.0L cv joint VIN: 1FMZU34E9X good day all. thanks in advance for any help. suv came in with noise in right front at about 30 mph on up. with truck running on the lift, the right hub bearing was making a lot of noise as was the axle tube bearing. we replaced both and went for test drive. t... |
View | |
| 2003 Ford Escape XLT 3.0L abs controller? master cyl? VIN: 1FMYU93173 I have heard the horror stories of doing a simple brake job in school and screwing up abs components, but have never had a problem or experienced it personally. I guess now its my turn. I put front pads on a 2003 ford escape for a friend of mine, collapsed the... |
View | |
| 2004 Ford Taurus SES 3.0L No Start VIN: 1FAFP55U64 I really need some help on this one.The car is a no start. It has spark,no fuel pressure.The FPDM has power output to fuel pump and back up to the FPDM so when I ground the pump at the FPDM the car starts and runs until I remove the ground.I am getting a 75% c... Trouble codes: P1235 (fuel pump driver module out of range), U1900 (can communication Bus fault receive error) |
View |
Fixes & Summaries for Ford
| Fix/Summary | Answers | |
| 2002 Ford Ranger XL 2.3L hard starting VIN: 1FTYR10D82 The fix was a sticking IAC. Anre originally mentioned the IAC. I finally saw the light after going to customers house one morning (about one mile out of my way) and the vehicle started perfectly but upon shutting it off and restarting the idle was very low. ... |
12 | |
| 2001 Lincoln LS 3.9L Left brake light VIN: 1LNHM87A11 Unfortunately the quality of replies were a little disappointing. Upon further inspection we realized the problem with the brake light can be duplicated by wiggling the connector to REM. However, a further step showed the wiring loom, right at the kink next... |
3 |
