|Prev||Professional Automotive Repair Technical Discussions for August 11, 2007
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|1998 Isuzu N NPR 5.7L Poor Idle Quality, Cuts out, Stall, MIL Lamp on VIN: 4KLB4B1R3X
i need some serious help. this box truck had a new motor put in and since then it stalls, hard to restart. when it stalls the cam retard goes to '45 degrees and the esc counter goes to 234 counts. you can restart it then you have to rev the engine to get the c... Trouble codes: P1345 (cam/crk correlation problem), P0341 (cam sensor out of range), P0325 (knock sensor problem)
|2003 Lexus ES300 3.0L power window VIN: JTHBF30GX3
car came in with window inop. we replaced the motor and now it goes up to the top and down 1/2 way,but only when using the auto up.I have tryed another switch and a OEM motor with no changes.
|1994 Nissan UD1400 135CID transmission VIN: JNAU4R1J1R
Hey guys, not much experience on these box trucks, so your help will be greatly appreciated! As you're going up a hill the trans. will not downshift into any gears and it just goes into nuetral. you pull off the side of the road, shut it down and start it ba...
Fixes & Summaries for Asian
|1991 Acura Legend LS 3.2L engine VIN: JH4KA8276M
thanks to everybody who replied i got 21 rep and almost everybody said it was main relay unfortnately my customer never appeared after that he was thinking to getrid of the car maybe he already did
|1994 Mazda 929 3.0L valves VIN: JM1HD4G12D
Yes, I had to bleed the lifters down. To do this I drained the engine oil and then slowly turned the crank by hand and let each lifter bleed down. Thanks for the help!!
|2006 Mazda B2300 2.3L Misfire, MIL Lamp on VIN: 4F4YR12D36
Ran into a brick wall on this one. Replaced DIS coil and CP sensor for the third time. Car runs better with OLD parts, and runs almost 100% if you warm it up first. Replaced plugs and wires and left them in due to mileage on truck. Best advice I can give on th... Trouble codes: P0320 (Distributor/Ignition Engine Speed Circuit).
|1997 Toyota 4Runner Limited 3.4L unknown VIN: JT3HN87R9V
well unfortunatly this one is not 100% fixed customer opted not to go any further some of the replyies i recieved where on drive shaft balnce front cv binding we did remove the front cv and opened it up looked ok wish i had a better answer and would like to th...