|
|
1994 Chrysler LHS 3.5L instrument cluster gages
good afternoon fellow technicians! i need some chrysler
help. i'm not sure where to go on this one. the gages and
gear lever position lights on instrument cluster are not
functioning 95 % of the time. they do occasionally work.
when they are inoperative the ai... |
View |
|
1996 Chrysler Cirrus 2.5L MIL Lamp on
I get the P0300 code when on freeway going 62 mph,or in
park holding the throtle at 2300rpm. The cam and crank
stays in sync always. The advance stays at 24 deg. I have
good fuel pressure, vaccum stays steady at 19. I cannot
feel a miss, car does not stumble. ... Trouble codes: P0300 (Multiple Missfire). |
View |
|
2004 Chrysler Concorde 3.5L Starting circuit
The problem is very intermittant. Turn key to start and
nothing. If the key is held to start for two seconds the
starter cranks. Does the PCM have the ground for the relay
through the tan wire? Can the tan wire be grounded and the
starter will work? The starte... |
View |
|
2004 Chrysler Sebring 2.7L No Start, No crank
Ok, I have this sebring here that I drove to my shop. I
went to look at it in the morning on the way to work and of
course, it started up just fine. Once I got the car down
here the car would not start. I traced the problem down to
the starter relay not being ... |
View |
|
1985 Dodge B350 5.9L compressor
this is a mexico bound friday 13 of july--it is mission van
with original miles--i replaced compressor and lines had
much rust etc--cleaned as much as possible and installed
new inline suction filter--charged to factory fill of 4
lbs-- no cool--pulled gas took... |
View |
|
1996 Dodge Grand Caravan 3.3L No Start, Poor Idle Quality, Hesitation, Cuts out, Stall, Misfire, MIL Lamp on
Came in as no start, no crank after intermittant dying
issue that they could not fix with above items. No mention
of CEL at this time. Replaced dead battery to fix no crank.
Engine had no spark on cranking until it eventually fired
and died, ran very poorly li... Trouble codes: p0351 (Coil 1 primary circuit). |
View |
|
1997 Dodge Grand Caravan 3.3L AC Heater Control Unit
Hello All,
This van came into the shop with the recirc and AC led's
flashing simotaniously. Tried the calibration procedure
from mitchell and no change. Cannot seem to retrieve any
trouble codes from unit. Not very familiar with this
system, any help would br... |
View |
|
2000 Dodge Grand Caravan 3.0L Instrument Cluster
Vehicle came in with a complaint of engine stalling and
check engine light on, Also stated that cluster is inop
with nothing working. Check codes found P0500 No Vehicle
Speed Sensor Signal and P1698 No CCD Messages From TCM.
Check basics found gauge #2 fuse bl... |
View |
|
2002 Dodge Intrepid 2.7L No Start
hi i have a 02 dodge intrepid giving me fits car is no
start had 0 fuel pressure and power at pump put in new fuel
pump pressure good now car still not starting no spark has
coil on plug ignition hooked up scan tool notice while
cranking engine that cam sensor... Trouble codes: p0700. |
View |
|
2003 Dodge Durango 4.7L air doors
Hello to all. Hope everyone is dealing with the heat wave.
I have this 03 Durango at the shop with customer complaint
of no A/C. Go figure this time of year. Anyway. There is
little to no A/C in front out of dash, but Realy nice cold
air out of the rear unit. ... |
View |
|
1997 Dodge Caravan 3.3L runs on after key of
many thank you's to all who responded.we finally found the fix.it turned out to be that pesky ptc 1 (positive temp coefficient) we measured voltage at end and noticed voltage would not drop to zero after ignition was shut off,instead it would dwindle from char... Trouble codes: P1282 (fuel pump relay), P1388 (asd relay circuit openshort). |
14 |
|
1999 Dodge Ram 2500 Truck 8.0L valvetrain
THANKS TO ALL WHO REPLIED- WHAT WE FOUND WAS THE ROCKER WITH THE BROKEN BOLT WAS SEVERELY GALLED AS WAS THE PEDESTAL- WHAT WE DETERMINED WAS THE EXTRA LOAD ON THE BOLT CAUSED BY GALLING IS WHAT BROKE THE BOLT-ITS GETTING ALL RIGHT BANK ROCKERS, PEDESTALS AND ... |
3 |
|
1999 Dodge Stratus 2.4L vtss
Finally we could disarm the vtss we have to make a jumper wire with a resistor of 470 ohms and jump from B+ and pin 20, connector C5 of BCM, with the vtss disarm we can now program a new fob, thanks to everyone who took the time to respond. |
2 |
|
2003 Dodge Dakota 3.9L No Start
The crank sensor was bad. Thank you all for your helpful responses.
Mark |
8 |
|
2006 Dodge Dakota 4.7L programing
Thanks guys for the answer I needed. since the cd subsciption is behind the latest interner dealer version but it works I found the software part number from the old unit and down loaded it from the cd transfered it with the usb key to star scan flashed the pc... |
9 |
|
2003 Jeep Grand Cherokee 4.0L No Start, Cuts out
Thanks to all for suggestions.We did replace the ckp with an o.e.,without success.At last check ,the check engine light flashed with koeo as I was setting up scanner to monitor data while starting,& set 8 dtcs.Unable to find any problem,we road tested for a co... |
15 |
|
1996 Plymouth Voyager 3.0L No Start
Thanks to everyone who took the time to read my post and reply. I had several interesting responses. Several suggested shorted harness or corroded connectors, but I had stated that I had a good cam & crank signal at pcm - also checked for opens & shorts with... |
7 |
|
Prev
