|Prev||Professional Automotive Repair Technical Discussions for April 22, 2007
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
Fixes & Summaries for Chrysler
|2000 Chrysler Grand Voyager SE 3.3L instrument panel VIN: 1B4GP4464Y
i measured vltage going through the ccd circuit and noticed it was 8.5 volts it was only supposed to be 2.5 on the high side.i started to unplug each module one by one while monitoring my voltmeter wich was connected to the ccd circuit at dlc connector until i...
|1997 Dodge Grand Caravan ES 3.8L Stall, Misfire, MIL Lamp on VIN: 1B4GP54L2V
Sorry for the late reply. After looking at this van further and rechecking everything, we even pulled the transmission, we still couldn't see anything. Then luckily it started acting up for us. After looking at the scope for a while I figured out that the alte... Trouble codes: P1391 (intermittent loss of cam/crank signal), P0352 (coil 2 primary circuit malfunction), P0140 (downstream o2 stays at center).
|2000 Dodge Ram 3500 Truck 5.9L No Start VIN: 1B7MC33781
I said in Original post that the truck came back in in Feburary for the 2nd pump. What I didn't mention was that the Fuel tank read a 1/4 tank like it did before (first time). I went down and got 5 gallons of fuel for it thinking gauge was bad and it didn't he...
|1994 Jeep Cherokee Country 4.0L housing mount VIN: 1J4FJ78S4R
All replies were helpful, I fixed the job from below the vehicle, but found it easier to get the housing started back on from above. My 94 Jeep had a 14mm hex bolt, and using a 14mm allen and sliding a breakerbar with a deep 14mm socket over the allen from und...