Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for March 5, 2007
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2006 Chrysler PT Cruiser 2.4L Poor Idle Quality, Cuts out, Misfire, MIL Lamp on VIN: 3AFY48B56T
HI.Im trying to help a tech that I work with.He originally changed the engine in a PT Cruiser that had been Wrecked,rad. busted,& overheated.Have a P0344 Cam sensor int.code.HE checked cam sensor,seems to have normal pattern.Valve timing is ok(eng. came with t... Trouble codes: P0344 (Cam sensor INt. signal.)
1996 Dodge Caravan 3.0L No Start VIN: 2B4FP2536T
I was so blessed as to have the opportunity to fix this van after several people have tried and failed. I first checked this van and found the crank sensor to be bad and the distributor (used one) to be installed incorrectly. Replaced sensor and stabbed distri...
1998 Dodge Caravan 3.0L Unknown VIN: 2B4FP2538W
This van came in with brake pedal going to floor checked all brakes and for leakage.replaced rear wheel cyls because of small amout of leakage.replaced master cyl at same time.came back 1 week later with pedal to floor replaced prp valve(valve assembly at rear...
1999 Dodge Ram 1500 Truck 5.9L cat melt down VIN: 1BZHF16XXS
customer complained of rough idle cold replace cap rotor and wires--6/3/2005--replaced intake manifold gasket on 8/9/06---cam back on 9/21/06 with no start and replace fuel pump and ran great--back on 11/08/06 with running bad replaced cap,rotor, wires and plu...
2004 Dodge Ram 1500 Truck ST 5.7L Hesitation, Surge, Cuts out, Stall, Misfire, stall VIN: 1D7HU1818U
Help this Hemi truck has died 3 times in the last week when turning or moving slowly when let off pedal to maintain a cruse speed engine will shutter or lurch acts like miss fire almost every time hit it hard runns well scan data looks good customer couldnt le...
1998 Jeep Wrangler Sport 4.0L timing chain VIN: 1J4FY19S8W
run a little rough at idle but runs fine going down the road. ran compression test again very low compression on all 6 cyl. pulled timing cover back off to inspect. by [...] it said to put it dot to dot and rotate the crank to bring the cam gear dot to 1 o...
1998 Plymouth Voyager 2.4L engine VIN: 2P4FP25B6W
customer brought vehicle into shop for us to check for a "metal tingy noise" when running also to check for some type of fluid leaking on the ground. located a large oil leak coming from the oil pressure switch (engine oil level was not low, just needed to be ...

Fixes & Summaries for Chrysler
Fix/Summary Answers
2001 Chrysler Voyager LX 3.3L No Start VIN: 1C4GJ45391
We had to let the van go. I called the customer, who said the dealer figured it out: they told him the computer was registering twice the mileage as the odometer & replaced some computer part - black, about the size of a cell phone, with lots of pins. He is su...
1993 Dodge Intrepid 3.3L Unknown VIN: 2D3DKSDFHE
We flushed the heater core for a real long time, seemed to help a little customer says he will get rid of car. thanks for the input guys!
2000 Dodge Intrepid 2.7L Poor Idle Quality, Cuts out, Stall VIN: 2B3HD46ROY
Thanks for all the replies. We still could never get this to act up for us or store a code. We took some of your advice and cleaned the EGR valve, throttle body and IAC motor. So far the customer has not complained of the problem coming back. I will make a fol...
2002 Dodge Ram 2500 Truck 5.9L torque converter VIN: 387KF23662
Thank you for all the replies. I'm sorry for waiting so long to close out. I just couldn't pull the trigger on this one so we sent it to the dealer. I was waiting for the customer to get back to me to let me know what they found but it's been two weeks and no ...
1998 Jeep Grand Cherokee Laredo 4.0L 3/4 shift VIN: 1J4GZ58S5W
Well, I ran out of time on this one.the trans is correct,numbers match 1998,the govener trans temp is silver correct for 1998 the pcm was changed with used and programed to latest calibrations,I checked resistance of temp sensor at tcm with 1000 ohm at room te...
2001 Jeep Cherokee Sport 4.0L engine VIN: NA
thanks to all replies. found cam bearings worn cuasing leak. replaced cam and bearings. now @idle (900 rpm) press is 25 psi thanks agian to all shayne
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next