|Prev||Professional Automotive Repair Technical Discussions for February 17, 2007
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Ford
|1971 Ford f 100 302CID wheel bearing VIN: 1FTAAB1112
This request is for you ford line techs. Since I don't do this work ( heavy line )I would appreciate any tips !!! 71 f 100 ( passenger side axle bearing is shot ) , are there any special probs. removing the axle , replacing the bearing , or general screw-ups ...
|1995 Ford Probe 2.0L No Start VIN: 1ZVLT20A9S
Hello Techs. I have a 1995 Ford Probe with a 2.0L DOHC Engine with a no start. Spark and Injector pulse are not present. After replacing the dead battery I noticed that the CEL light would light up for about a half a second and then go out. A few seconds later... Trouble codes: 556 (Fuel pump HFP relay primary circuit failure)
|1999 Ford F-150 4.2L thrust bearing VIN: IFTDX1729V
Truck came in the front case leaking oil, while tech was pulling the crank pully ad noticed a lot of thrust play. The truck has only had about 1500 mile on the motor sice rebuild had been done. Almost 1/4 inch of thrust play. Help me out guys, I have seen post...
|2001 Ford F-250 Super Duty XL 5.4L no 4wd when shifted to 4l VIN: 1FFAT988B9
GUYS, THIS ONE IS BIZZARE. The trucks operates normal when shifted to 4H. When shifted to 4L the transfer case motor makes a grunt, then knocks out of 4Wd to 2WD. All the test we ran show a possible transfer case module, we don't really beleive it. The Alldata...
Fixes & Summaries for Ford
|1993 Ford Ranger STX 4.0L brake pedal VIN: 1FTCR14X1P
I replaced the brake booster and that fixed it, but removing vacuum from the booster to see if it goes away didn't work because it still did it, thanks everyone for the replies.
|2005 Ford F-350 Super Duty XL 6.8L engine VIN: 1FTWW33Y95
Thanks for replies. I was checking to see if this was a common problem before truck goes back for warranty repair/make sure customer was well informed beforehand. Guess is just a 'lemon'.