 Prev |
Professional Automotive Repair Technical Discussions for January 21, 2007 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 1999 Mazda B2500 SE 2.5L piston liners/cylinders DIESEL ENGINE NONE TURBO . NOT GAS This engine was O/H by me, done maybe 450 diesel engines and as many gas . What i would like to know or confirm . Is i sent the block out to get new cylinders/ sleeve's put in finished the O/H and sent out the truck. Two mo... |
View | |
| 1998 Subaru Legacy Outback 2.5L Poor Idle Quality, Hesitation VIN: 4S3BG6858W This vehicle has had a rough idle since the owner purchased about 6 months ago.Hesitation pulling away after warm up is very intermidite.Just finished re-ringing engine and idle condition did't improve.Have checked fuel pressure,cleaned injectors and MAF,no pr... |
View | |
| 2006 Suzuki G/VITARA 2.0L 4WD Control System VIN: JSAJTD54V0 This car is equipped with transfer with shift motor type which is controlled by 4WD control module also full time 4WD when you select the 4H poisiton(Suitable for normal driving) Now 4L, N, and center diffential lock indicator blinks together for a moment and ... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 1991 Isuzu Rodeo LS 3.1L Cuts out, VIN: 4S2CG58Z2M well thanks to those that replied, i had to go old school on this being i didnt have right scan tool, i just hooked up my dvom to tcc wire out of the tcm, it was engaged at all times, relaced tcm and goes into lockup when supposed to, also replaced solenoid an... |
5 | |
| 1994 Nissan Altima GLE 2.4L speedo VIN: 1N4BU31D3R cars fixed. it was the heads up display module consuming the ac voltage from the rpm. i disabled the speedo and the tach started working again. i could not find any burnt traces or cold solder joints. but i believe it was the flash chip in the module itself. i... |
3 |
