 Prev |
Professional Automotive Repair Technical Discussions for November 6, 2006 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Chrysler
| Help Request | Answers | |
| 1999 Chrysler Cirrus LXi 2.5L Surge, Cuts out, Stall VIN: 1C3EJ56H1X hello again chysler techs , this one runs good then the idle will surge some times stall always starts right backup one time after stalling got a one trip code for park nuetral switch ? that one has me puzzled did not wright code # down when idle surges mil co... |
View | |
| 2000 Chrysler Concorde LXi 3.2L Overheat VIN: 2C3HD36JXY . Car came in overheating. I replaced the upper rad hose and thermostat. Dealer t/stat was used. Flushed cooling system, then vacuum bled. Still overheats on highway. Any advice? Ill try checking head gasket tomorrow. |
View | |
| 1952 Dodge Coronet 230CID engine This is a clean old car that is mechanically O.E. I just need to know what weight engine oil and whether to use detergent or non-detergent. I am in S.W. La and the climate is tropical. It still has the flathead straight 6, and positive ground 6 volt. Thanks. |
View | |
| 1998 Dodge Durango 5.2L No Start VIN: 1B4HS28Y2W i have a no start problem here. no codes in computer, no spark, injector pulse or fuel pump running. i did test the asd relay again and it is working now. like always i left it sit over the weekend and know it started up when we went to pull it in and check it... |
View | |
| 2001 Dodge Ram 1500 Van 5.2L No Start VIN: 2B6HB11Y21 Van intermintenly no starts when this occurs there is no spark or injector pulse, fuel pressure is ok. Instrument panel says NO BUS where the odometer reads. Have tried unplugging each module one at a time on the data line when problem occurs still no starts. ... |
View | |
| 2002 Dodge Grand Caravan Sport 3.3L Excessive Emissions, No Start, Poor Idle Quality, Stall, ?????????? VIN: 1B4GP44392 HELP!!! This one came in on the hook for a No-start. Customer states van has been running just fine and yesterday morning would not start. (1st really cold morning we've had here.)(about 38 deg overnight). So it was towed in. Van arrived and of course no start... Trouble codes: P1299 |
View | |
| 2003 Dodge Stratus ES 2.7L A/C Mode Door VIN: 1B3EL56T63 I have this Stratus that came in with the A/C system in default. The codes are Matured Fault present and A/C mode door input open/short to ground. I cleared the code but returned right away. I reset the bcm and tried to calibrate the A/C again, no help. I foll... |
View |
Fixes & Summaries for Chrysler
| Fix/Summary | Answers | |
| 1997 Chrysler Town & Country LXi 3.8L engine dies VIN: 1C4GP64L8V I am sorry to have to write this close, but I was not able to find the cause to the dying problem on the chrysler town and country. I received 17 very good replies and appreciated each one. The cam and crank sensors were both from chrysler which a few recommen... Trouble codes: P0340 (no cam signal to pcm), P0106. |
17 | |
| 1997 Jeep Wrangler SE 2.5L convertor VIN: 1J4FY29POV After some more testing the problem was found to be mechanical. The trouble code stated a TCC circuit failure. The customer has decided not to spend the money to repair the transmission at this time. |
6 | |
| 1997 Jeep Grand Cherokee Laredo 4.0L cluster/windows VIN: 1J4FX58S2V by sheer luck we found the BCM to be faulty.the dash, locks,windows and every elactronic module (compass,etc)runs thru the BCM on this car.each item if shorted, can cause the dash to flicker.by tapping on the bcm, under the steering, we were able to make the p... |
13 | |
| 2002 Jeep Grand Cherokee Limited 4.7L compressor operation VIN: 1J8GX58N02 I have to post a very embarrasing repair. Several replys were right on the money with the evap temp sensor. Funny thing is that Mitchell does not show the sensor on the HVAC diagram. The problem was that the tech did not transfer the sensor to the new evap cor... |
13 |
