Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for November 5, 2006
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for European
Help Request Answers
1993 Mercedes-Benz 190E 2.6 2.6L Suspension VIN: WDBDA29D2P
this gem has a clunk in the back when the transmission shifts. found the dampner between the trans and driveshaft worn. replaced it thinkking i had it but it still clunks in gear. put it on the lift and i can see the whole rear shifting when it shifts. there a...
1996 Volvo 850 2.4L MIL Lamp on VIN: YVILW5545T
Hello all This Volvo is a regular in our shop. We see it every 5000 miles for it's regular maintenance. Our customer ran over something in the road and broke her evap cannister in the LF fender area. We ordered a new one and installed it. After car left, we go... Trouble codes: P0440 (Evap Emission Control)

Fixes & Summaries for European
Fix/Summary Answers
2002 Audi A4 1.8L engine noise VIN: WAULC68E52
The right fix was to replace the cam tensioner.Even very clean oil srceen at the old tensioner,and we're very certain that the car was well maintain.No sludge oil pressure in spec. Most of you were right.Special thanks to John and all of you who replied so qui...
2002 Volkswagen Jetta GLS 1.8L No Start VIN: 3VWSE69M02
Thanks for the help all. The cam chain on the back of the cyl head only had 15 rollers between the marks instead of the 16 required. Although all timing marks still lined up the chain adjuster assembly was moving the intake cam out of sync and causing an impro... Trouble codes: P0341 (Cam sensor A CKT OBD II generic on Mac Mentor).
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next