|Prev||Professional Automotive Repair Technical Discussions for September 3, 2006
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for GM
|1993 Buick Skylark Custom 3.3L No Start VIN: 1G4NV54N8P
hey guys, i have one thats driving me nuts this will be a bit long, sorry. to start with i had no CEL & could not communicate with the ECM. i repaired a problem with 1 power wire & found a bad ground which got me a working CEL & communications. hit the starte...
|1997 Chevrolet S10 4.3L 1st gear VIN: 1GCDT14X7V
Hey guys, my pai S10 is back. Before I gave it back I decided to do oil change and trans service.All was fine until I test drove it, in 4th or 3rd gear trans slips on take off until 25- 30mph. Ieven tried putting old filter back in thinking I had a bad one- no...
|2000 Saturn SL2 1.9L Misfire VIN: 1G8ZK5279Y
Well, I can't find a crank sensor on this piece. However I do know I am losing spark to cylinders 1 & 4 when it's cold, sometime warm it runs great, but most of the time it misses. I have swapped coils, I have even ran it without the coil on the module to watc... Trouble codes: P0340 (Cam Shaft sensor), P0341
Fixes & Summaries for GM
|1997 Pontiac Grand Am SE 2.4L No Start VIN: 1G2NE52T2V
well, the overwelming connsensus was replace the coil housing even though there where no signs of carbon tracking and it ohmed out fine. Thats what I did, and, bingo, fire in all four holes. Thanks too all that replied. Very much apprieciated. This ones a fix.