Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for July 5, 2006
International Automotive Technicians' Network (iATN) - Members Only
Next
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Ford
Help Request Answers
1986 Ford Ranger STX 2.9L Cuts out VIN: 1FTCR14T7G
Vehicle starts & runs fine cold. Idle turns rough & stalls after 15 to 20 minutes...acts like heat soak problem. Replaced I/M twice, replaced distributor, cap, rotor and coil. Watched fuel pressure gauge for any sign of deterioration and found none. Problem re...
View
1995 Ford Contour GL 2.5L engine VIN: 1FALP65L0S
Thanks for any help offered, This contour has the 2.5 v-6. Car is pumping antifreeze out both ends. Customer shut it down as soon as the problem happened. I would like to see how deep the water is, and the customer how deep into his wallet this will be, before...
View
1995 Ford Contour GL 2.0L Hesitation, Cuts out VIN: 3FALP65325
the air box has slight damage near the mass air senser were the clip holds it on
View
1999 Ford F-250 Super Duty Lariat 7.3L Poor Idle Quality, Surge VIN: 1FTNX21F5X
hello and thanks ahead of time for the help and hard work we all put in this is for all the diesel techs out there. this trk came in stright off the road and customer complained of an intermitant trouble the trk would miss when you come off of a hyway run he d... Trouble codes: P0605, P0266 (cyl 2 contribution /balc fault), P0275 (cyl 5 contr / balc fault)
View
2000 Ford Expedition Eddie Bauer 5.4L obd ii VIN: 1FMPU18LXY
hi guys i got this 2000 ford expedition came in with code 171&174 replace o2 sensors & mass airflow & new pcv hose, everything is fine except the system wont get ready for state emission o2 & egr are ready but cat & evap not ready yet which i drove this truck ...
View
2001 Ford Windstar LX 3.8L Misfire VIN: 2FMZA55431
alright guys, i got this windstar in last year we did plugs and wires the guy said the engine light never went out.had a pretty dead miss. i tested the injectors by using a noid light and driving on dyne, found the injector driver for cyl 2 intermittently diss...
View
2003 Ford Mondeo 2.0L compressor continus engage VIN: WF0TB16FX3
hi my best groub this Mondeo with manual AC climate control, the broplem is compressor cluch some times engage evine the AC SW off,you can verify the concern at any time ,also some time instrument cluster all indecator comes on and all guage not work but momen...
View

Fixes & Summaries for Ford
Fix/Summary Answers
1996 Ford Contour GL 2.0L No Start VIN: 1FALP6537T
Thank you for all the replies. I could find nothing wrong with the car I tried a different MAF and ECM with no change. The cam timing is perfect. I am guessing the flex plate may be damaged but am unsure. I have lost too much money on this already and am sendi...
7
1999 Ford F-350 Super Duty Lariat 7.3L noise VIN: 1FTWW32F4X
Thanks for all the replies! The turbo ended up being the cause of the noise. I have never done much turbo work before so I was not sure what the turbine fins looked like when new, the ones on this turbo were 'swept back' like a fan blade and they were all even...
7
1999 Ford E-150 Econoline 4.2L #11Fuse VIN: 1FTRE1423X
Thanks for all the help on this difficult repair.The fix was a repair in the harness to the left rear light @ the top of the van. Being a work van,this truck had a rack mounted on the driver side with a piece of metal stripping about 5 feet long which shifted ...
13
1993 Mercury Grand Marquis LS 4.6L Misfire VIN: 2MELM75W3P
Finally got this vehicle running good, problem ended up being a fuel pump. Would get to specified pressure but wouldnt hold at all, also very low volume. Thank you for all your good ideas and help
16
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next