|Prev||Professional Automotive Repair Technical Discussions for May 13, 2006
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|1995 Dodge Dakota 3.9L No Start VIN: 1B7GG26X9S
Hi this truck was towed in with a no start . Customer has replaced engine and trans w/ reman units and has never started since. when truck did not start the owner replaced pcm , still no start . Then I was the lucky one . truck towed in and I check for injecto...
|2001 Dodge Ram 1500 Truck 5.2L gov psi VIN: 1B7HF16Y11
We scanned Pcm and code 1762 appeared cleared it and came right back. ATF temp seems ok. output speed ok. Gov psi voltage is .76, regardless of engine running, or KOEO, or going 30 miles an hour down the road. Gov psi reads 17 psi always just like voltage. All...
Fixes & Summaries for Chrysler
|1997 Dodge Neon High Line 2.0L Brake pedal VIN: 1B3ES47Y3V
I would like to thank everyone for their suggestions, all very good ideas. We clamped brake hoses and came up with nothing, finally we changed the master cylinder again and had a better pedal, and after a ridiculous amount of bleeding I believe it is finally d...
|1998 Jeep Grand Cherokee 5.9 Limited 5.9L Mechanical VIN: 1J4GZ1WC12
Sorry for the delay fellow techs, but I wanted to make sure this jeep was running and I got as much info as possible from Mr.SJ (SIDE JOB) before closing this help request. As far as being an interference fit, the responces were split. Robert from GA may have ...
|1996 Plymouth Grand Voyager 3.0L No Start VIN: JFJJFGF587
hey guys sorry for taking so long to close this one it turned out to be abad computer.Put a new one in there and it started up and runs like a charm.Thanks for the help guys.