× Auto Repair Pros Member Benefits TechHelp Knowledge Base Forums Resources My iATN Marketplace Chat Pricing About Us Join Industry Sponsors Video Members Only Repair Shops Auto Pro Careers Auto Pro Reviews
Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 9, 2006
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1984 Chrysler LeBaron 2.2L Hesitation, Cuts out, Misfire VIN: 1C3BC55E7E
It has been a long time since I have seen one of these in my shop. This car falls on its face when you try a hard accelleration and will buck and backfire. We have spent alot of time on this one. There were several vac leaks repaired, we have checked the archi...
1999 Dodge Ram 1500 Laramie 5.2L blend door VIN: 1B7HC16Y1X
We replaced the evaporator in this vehicle and when it was restarted, the temp door moved to full heat and would not go back to cold. We had good cold air when we tested system initially and temp door would move properly. Everything is plugged in and all fuses...
2002 Dodge Intrepid SE 2.7L Poor Idle Quality, Misfire, MIL Lamp on VIN: 2B3HD46RX2
This vehicle came to us a couple of weeks ago for a check engine light. All we had time for was to scan it, at which time we found the p0132 1/1 o2 sensor voltage high. Cleared code and sent her on her way. The customer tells us the light was back on within a ... Trouble codes: P0340 (cmp sensor ckt), P0152 (2/1 o2 sensor voltage high), P0132 (1/1 o2 sensor voltage high), P0300 (multiple cylinder misfire)
1997 Jeep Grand Cherokee Laredo 4.0L MIL Lamp on VIN: 1J4GZ58S5V
from dead cold as the trans shifts in to 4 gear if gas pedal is released trans will downshift to third gear then mil goes on sets only trans code p0753 3-4 solenoid, reapply gas and car lugs then reshifts to 4 gear, mil stays on, Trouble codes: P0753 (trans 3-4 solenoid), P0463 (fuel sender volts high)
2001 Jeep Grand Cherokee Laredo 4.0L crankshaft thrust bearing VIN: 1J4GX48S01
This vehicle came in with a noise when running. We found the flywheel rubbing the back of the engine. Pulled engine down, found thrust main bearing and rear crankshaft thrust surface worn completely out. (1/4") travel. All flat bearing surfaces were fine, as s...
2000 Plymouth Grand Voyager 3.0L limp mode VIN: 2P4GP2434Y
this one is my personal van (my wifes van). the problem is that after about 20 miles on the high way the service engine light comes on and the trany goes into limp mode. when i check the codes they are different it has set a p1784 i cleared codes.the next time...

Fixes & Summaries for Chrysler
Fix/Summary Answers
1995 Dodge Intrepid 3.3L transmission control module VIN: 1B3HD46T0S
Hi Thanks to Terry, Brad, Chris, Kevin, Thomas and Steve. Most people leaned twords speed sensor faults since that is the most common problem with these. My problem however was the tccm going bad and no matter how long it was unhooked it would't work again but...
1998 Dodge Caravan 3.3L No Start, Stall VIN: 1C4GP54LXW
Well this one is finally out the door.Many thanks to Mark,Charles,Duane,Savoeun,and William for taking the time to reply.Ultimately this one turned out to be a cracked flywheel.I have run into this before but not with these exact symptoms.I even spoke with the...
1999 Dodge Ram 2500 5.9L Surge VIN: 1G7KF2368X
I replaced the tcc solenoid and that fixed the problem of this truck surging at 40 mph .
2000 Dodge Grand Caravan SE 3.8L Fuel Gauge VIN: 1B4GP44R7Y
Checking the sender volts with a scan tool while driving, I sent the van to the local dealer for a BCM reflash.I was told that there were no updates, so I replaced the Module and after a week of use the gauge is reading correct.
2001 Dodge Grand Caravan SE 3.3L cruse control VIN: 1B8GP24371
Special thanks to Alfred, Thomas, Mark, Cam, Tim and all the rest of you guys. Several of you hit it right on the nose. I believe that it was Alfred that said that it was a piece of cake and he was right. I swaped out the column because mine diden't have cruis...
1998 Jeep Wrangler Sport 4.0L Hesitation, BACKFIRE WHEN COLD VIN: 1J4FY19S0W
thanks to tom the chrysler tech. you nailed it. the o2 sensor was the culprit. thanks for all the help guys.
1998 Jeep Wrangler SE 2.5L MIL Lamp on VIN: 1J4FY29P5W
This sounds strange but it was a wiring and terminal problem. All the wires ohm tested fine from the IAC to PCM. Ended up replacing the wire and terminal that ohm tested fine and had 12 volts from the PCM to the IAC but wasn't switching on/off. Edward from Ari... Trouble codes: P0505 (iac).
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next