Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for May 1, 2006
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
1996 Chrysler Sebring JXi 2.5L cooling system VIN: 3C3EL55HXT
car came in with bubbling noise under hood. did block test came up positive for exhaust gases in coolant.removed heads and replaced gaskets , sent to machine shop. replaced heads test drove still bubbling sound. replaced engine customer has been driving for 6 ...
1997 Chrysler Sebring LX 2.5L distributor VIN: JHMCB756XM
Hello fellows this vehicle came in for a hesitation, sagging on acceleration. There were a few TSB on replacing the distributor, after checking the ignition, fuel pressure, and the exhaust along with the pcm data screen we decided to replace the distributor. T...
2004 Chrysler Sebring Touring 2.7L Noise VIN: 1C3EL56R74
Car has a poping/clicking type noise that seems to be from the engine side of the firewall in the general area of the accelerator pedal, noise is most noticable at 40 mph and above,the noise once it starts may do it several times like pop pop pop, turning,brak...
1998 Dodge Intrepid 2.7L No Start VIN: 1D489D9643
Ok I got a good one.I have a 1998 dodge interpid that will not start with the cam pos sensor pluged in.I will start with it unpluged.The customer installed a new cam sensor but it didnt work.I put a dvom on the 8 volt side of the sensor and when i plug it in i...
2001 Dodge Durango SLT 4.7L mode door VIN: 1B4HS28N51
Hi All, Customer came in with a complaint of the heater always being on defrost with no movement of the mode doors. I confirmed this and then hooked up my OTC scanner and pulled an EEPROM error code from the HVAC system. Alldata said to replace the heater cont...
2001 Dodge Ram 1500 Van 5.9L compressor VIN: 3B7HC13Z01
Ok, my tech is stumped. He thinks we are dealing with electrical on this Dodge, I think otherwise so that is why I am posting this request. This 01 Ram 1500 starts up with ice cold AC, when this truck runs for about 10 mins. the engine starts acting like the c...
1999 Jeep Grand Cherokee Laredo 4.7L engine VIN: 1J4GW58N8X
i have a jeep that dies it will crank back after 15 min to an hour fuel pressure is ok current ramped the pump ok i can get it to act up for me and it is the customers only ride so she cant leave it, i really cant say what its missing, it does show that it has...

Fixes & Summaries for Chrysler
Fix/Summary Answers
1999 Chrysler Sebring JXi 2.5L No Start VIN: 3C3EL55H9X
After putting two carquest crank sensors that scoped out. installed a oem sensor and car started and ran fine. Thanks everyone for the help...
1992 Dodge W250 5.9L Rear Brakes VIN: 3BTKM23C1N
Thanks to the many responses, but real problem was defective new booster. Funny, didn't feel any different new to old, but had much better braking and almost double pressure at rear cylinders. Before booster replaced had 500-750 psi, after booster replaced had...
1995 Dodge B2500 5.2L air bag light VIN: 2B6HB21Y7S
Im 90% sure its the clockspring too, but would like to get data from ccd to be sure still gathering cost and labor info (sorry for the wait) ill have an answer asap!!
1997 Dodge Caravan 2.4L flex plate harm bal VIN: 2B4FP25BSV
well fellrz, i lookd at th flex plate n it was crackd. i pricd th job n orderd th part per th customers request. but for an unknown reason he never came back for th repair. i'm guessing that he found a cheapr place (back yard, maybe ) after he learnd what it w...
1998 Dodge Ram 1500 Truck 5.9L vibration drivetran VIN: 3B7HF12Z5W
Pickup is finely fixed.I thought and several suggested that noise was in transfer case or drive shaft.The way the viberation would come through floor board.Started driving pickup till noise got worse and found noise & viberation comeing from front drive shaft....
1995 Eagle Talon TSi 2.0L Poor Idle Quality, Cuts out, Stall, Misfire VIN: 4E3AL54F6S
The car is running like new. You hit the nail right on the head telling me to use the NGK plugs on this 4G63 2.0L turbo engine. I can stand on the boost hard now with out any cutting out It runs smooth now from idle to 7000rpm. Looking at the autolite & NGK si...
1987 Jeep Wrangler 2.5L No Start VIN: 2BCHV81S7H
Thank you to everyone who helped me on this Jeep.The problem was two-fold. I had to replace both the crank sensor and the ign, coil. Just to verify that both were bad, after the vehicle was running, I swithed back the parts one at a time and verified that both...
1999 Jeep Grand Cherokee Laredo 4.0L cool fan relay VIN: 1J4GW58S5X
Hi and Thanks to All, I had 22 replies with 2 ways of going about getting to this relay. Thanks to Michael [...]...
1994 Plymouth Voyager 3.0L Excessive Emissions, Poor Idle Quality, Misfire, MIL Lamp on VIN: 2P4GH2532R
I guess that this one is for the HISTORY BOOKS. The vac leak and the injector code are related, I repaired the vac leak and the code HAS NOT re-surfaced at all. I suppose this was left out of the repair tree. For sure this will help someone in the future if a ... Trouble codes: 27 (fuel injection circuit).
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next