 Prev |
Professional Automotive Repair Technical Discussions for March 12, 2006 International Automotive Technicians' Network (iATN) - Members Only |
Next  |
| (Also Available: All, Asian, Chrysler, European, Ford, GM.) | ||
| Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder. | ||
Open Help Requests for Asian
| Help Request | Answers | |
| 1992 Honda Accord EX 2.2L oil leak VIN: 1HGCB727XN think I covered everthing in repair history, have no explanation of why leak has disappeared with crank pulley removed. Wouldn't assume there was that much pressure on pulley cause a seal leak but I could be wrong. |
View | |
| 1998 Lexus ES300 3.0L Misfire, MIL Lamp on VIN: JT8BF2861W Hi this is a friends son's car which had been parked while away at collage. Some fury rodents have chewed the injector wires on the back bank clear down to the injectors. Lexis wants to sell a complete harness.Are there any Toyota / Lexis techs that can tell m... |
View |
Fixes & Summaries for Asian
| Fix/Summary | Answers | |
| 1994 Honda Civic DX 1.5L Mechanical everybody said that there is only one auto trans m24a no one know of a s34a auto trans |
6 | |
| 1997 Infiniti QX4 3.3L Excessive Emissions, Poor Idle Quality, Hesitation, Cuts out, Stall, Misfire, Poor Fuel Economy VIN: JFN01VW089 Thank you for all the info, it turned out to be two seperate items. The catalytic converter was bad and caused the exhaust to go cherry red. The other problem was caused by the distributer. Thanks again, Adam |
3 | |
| 1993 Nissan 240SX 2.4L No Start VIN: JN1MS34P7P What a great responce I recieved for my question. As soon as I read the responce that the temp. sensor could be telling the ecm that the motor was hot i new this was the answer. sure enough i found a faulty connection for the temp sensor. not to easy to see on... |
17 | |
| 2000 Nissan Frontier XE 3.3L Surge, Cuts out VIN: 1NGED27Y3Y Thanks for the replies and I did recheck the Maf sensor but it went full range and the injectors were not the problem they were actually being shut down by the computer. The culprit ended up being the TPS adjustment. My Tech had originally set the TPS to .42 a... |
8 |
