Join Now
International Automotive Technicians Network
Prev Professional Automotive Repair Technical Discussions for February 3, 2006
International Automotive Technicians' Network (iATN) - Members Only
(Also Available: All, Asian, Chrysler, European, Ford, GM.)
Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.

Open Help Requests for Chrysler
Help Request Answers
2001 Chrysler Voyager 3.3L ears VIN: 1C4GJ25G01
Customer brought the vehicle in for a general inspection and oil change, complained of high pitch squeel noise from engine. The noise comes from the intake area. I have heard this noise on many vehicles with plastic intakes, only it is much louder on this car....
2002 Chrysler Town & Country (Van) LXi 3.8L No Start VIN: 2C4GP44382
Vehicle was parked on incline with steering straight ahead. Customer had taken key from ignition. When he finished his errands, put key in ignition, switch would not turn but steering had not locked. Van will not let ignition unlock or transmission shift. Pull...
2003 Chrysler Town & Country (Van) LXi 3.8L steering VIN: 2C8GP54L83
custumer took his van in for new tires, got it back and now pulls to left all the time. we rotated tires front to back and side to side, checked to make sure brakes are ok, front pads have 1/4 pads, and backs have 1/2 pads, calipers all feel free, still pulls ...
1994 Dodge Intrepid 3.3L stays in limp mode VIN: 1B3HD46T1R
Car will shift fine sometimes, other times has delayed reverse and then stuck in limp mode(1st only). If you clear codes car will act normal. also customer says when it is stuck in 1st he will cycle the key a few times and then catr will shift fine for a while...
1999 Dodge Neon High Line 2.0L Extended crank VIN: 1B3ES42C9X
I need help finding correct cam sensor. The one off the car has an indentation to receive the rear of the cam shaft and the one from aftermarket or dealer is flat. The dealer tells me that the cam has shifted. I fine this hard to belive since the car runs grea...
1999 Dodge Neon High Line 2.0L alt. light on VIN: 1P3ES47C9X
Hello fellow techs. This neon has a wierd charging system problem. It will not charge the battery intermittently. While driving or idling, the battery indicator will come on and at that time, will not be charging,,,according to the scan tool and the volt meter...

Fixes & Summaries for Chrysler
Fix/Summary Answers
1996 Dodge B1500 3.9L Misfire, MIL Lamp on VIN: 2B6HB21X4T
Thanks for all of the info, but the problem is unresolved. It's so intermittent and light I cant seam to find the mis. Customer is going to drive until more consistant, maybe I can find it then. This vehicle was the deciding factor in joining IATN, and I can,t... Trouble codes: 300 (random misfire), 301 (misfire 1), 303 (3), 305 (5).
2000 Dodge Caravan 3.3L headligts&dash VIN: 1C4GJ44G3Y
thanks to all who replied. after checking power and grounds at the bcm ,ohm test on the light switch and dimmer switch i replaced the bcm .pierre and daniel said they are prone to failure and could be programmed by the manufacturer anyhow the bcm was the probl...
1992 Eagle Summit DL 1.8L no crank/start, no dash lites, driver's side shou VIN: JE3CV20D1N
Thanks to those members who responded. Although nothing obvious showed up, we did check the wiring under the battery and radiator and cleaned and inspected all the connectors. In addition we also replaced the negative battery cable as there was some corrosion ...
1988 Jeep Cherokee Limited 4.0L Excessive Emissions, Poor Idle Quality VIN: 1JCMT7893J
Well this one is fixed. Many great replies saying the O2 should be replaced (which I did), and the TPS adjusted to .4V which I also did. The next Emission test passed with flying colours and my high idle complaint never returned. The only thing left unsaid was... Trouble codes: 55555 (No code readout with MT2500).
1996 Jeep Grand Cherokee Laredo 4.0L No Start, Stall, MIL Lamp on VIN: 1J4GZ58S3T
thanks for the help! i forgot to mention that i had also replaced the crank sensor becuase i got a crank sensor code after replacing the distributor (the crank sensor signal looked ok, but i replaced it anyway). to fix the vehicle, i actually had to reinstall ... Trouble codes: P0340, P0320.
Prev (Also Available: All, Asian, Chrysler, European, Ford, GM.) Next