|Prev||Professional Automotive Repair Technical Discussions for January 14, 2006
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
Fixes & Summaries for Chrysler
|1988 Dodge Dakota 3.9L No Start VIN: 1B7GR14X2J
Thanks to all that replied, Vehicle had 3 problems, First was ECM, Red wire that fed ASD Relay only had 7 volts, Checked wire in loom, found loose crimp on connecter, wire would have 7 volts then unhook ECM hook back up would have 12.75 Volts vehicle would the... Trouble codes: 44 (Fused J2 Input).
|1994 Dodge Ram 1500 Truck 5.2L Excessive Emissions, Poor Fuel Economy VIN: 1B7HC16Y4R
Customer is trying to find a similar truck to try swapping the ecm, before buying a new one since there is not a definite answer to this problem
|1998 Dodge Dakota 3.9L Clutch VIN: 1B7FL26X4W
Thanks for all the replies. Sorry to take so long to close, but the customer could not bring the truck back until now. As many suggested, the pilot bearing was trash, all the needles fell out when I pulled the tranny. The throwout bearing was bad also, so we p...
|1994 Jeep Wrangler S 2.5L No Start, Stall, HARD COLD START VIN: 1J4FY19P4R
thanks for everyones imput. David from michigan helped the most. After checking again, I noticed the check engine light does not eluminate after sitting about a day and a half when key is first turned on. I also noticed after sysling the key it finally did com...
|1997 Jeep Wrangler SE 2.5L master cly VIN: 1J4FY29P5V
this vechile has been repaired . the problem was the customer installed the wrong wheel cylnders,abs units,vechile did not have abs. thanks to all who replied to our request. thanks to lorne from california for the great tips.
|1999 Jeep Grand Cherokee Laredo 4.7L MIL Lamp on VIN: 1J4GW58N5X
I reflashed the instriment cluster with the lastest update and the CEL is off now. Thanks to all who responded John [...]