|Prev||Professional Automotive Repair Technical Discussions for January 2, 2006
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Asian
|1992 Honda Civic DX 1.5L No Start, MIL Lamp on VIN: 2HGEH2353N
This is one of my own cars and has burned down three pcm's now. What happens is the pcm quits working. I have checked the distributor and all grounds and powers to the pcm. The main relay is ok.. The ignition switch has been replaced. Igniter and coil are good...
|1995 Honda Civic EX 1.6L Transmission VIN: 1HGEJ1223S
Hi all. Car drives fine in Drive until warm, at which time it lets go and will coast to a stop in traffic in D. Will engage again once it cools down. I've seen this many times, and it's called "Let's never change the ATF in 11 years." So it's most likely va...
|2002 Hyundai Sonata 2.4L timing components VIN: KMHWF25S92
Well as you can see above there have been many hands in this pot! This car started having it's timing problems at approx. 60k and the owner had the timing belt replaced at another shop. At 75k the owner of the car had yet a different shop put yet another timin...
|1988 Mazda RX-7 GTU 1.3L drivetrain VIN: JM1FC3317J
Car came in with vibration. We replaced the driveshaft with new unit from powertrain industries. The front u-joint was bad. Also checked engine and transmission mounts. The car has a steady vibration, stronger on acceleration, but feels like throughout the car...
Fixes & Summaries for Asian
|1996 Honda Accord LX 2.2L non-start;intermittent VIN: 1HGCD723XT
I am closing this help request without a fix. The girl's father declined my recommendation for a new EFI relay and a dist. cap and rotor. Thanks to all who responded. Dad will be getting a very distressed phone call, I'm sure, sometime in the near future. Oh w...
|2001 Honda CR-V EX 2.0L MIL Lamp on VIN: JHLRD18641
I checked the valve adjustment and sure enough #4 and #2 were just a bit tight. I adjusted the valves, cleared the memory and that took care of it. I'm surprised that this ecm can pick up a misfire that I could not. Hey, you learn somthing new every day. Thank... Trouble codes: P0505 (idle control system malfunction), P0304 (cly 4 misfire).
|2003 Isuzu Rodeo S 3.2L No Start VIN: 1GRWSDMHGT
the general consenus was to have the vehicle programed at the dealer, this vehicle became the property of my shop after being stolen from the lot, vehicle has no wheeels or tires and has been beaten up preety good , shop owner wanted to hear run before sinking...