|Prev||Professional Automotive Repair Technical Discussions for December 10, 2005
International Automotive Technicians' Network (iATN) - Members Only
|(Also Available: All, Asian, Chrysler, European, Ford, GM.)|
|Vehicle Owners: If you are seeking an automotive repair professional to service your vehicle, visit the iATN Repair Shop Finder.|
Open Help Requests for Chrysler
|2001 Chrysler PT Cruiser 2.4L Ball Joint / Steering Rack VIN: 3C8FY4BB71
This PT Cruiser keeps coming back for suspension noise. After the previous repairs, it seems ok for awhile then returns. The problem now is a loud knocking in the front end when turning over bumps. The only noticeable loosness is in the rf lwr ball joint, bu...
|2001 Dodge Ram 3500 Truck 5.9L Electronic VIN: 1BMF33641J
This truck will set the code everytime you go down the highway under moderate throttle. We have scoped the sensor wire and the voltage does in fact go over the 4.79 volts for 8.5 seconds which is required to set the code. We have installed a gauge on the gov p...
Fixes & Summaries for Chrysler
|1992 Chrysler New Yorker Fifth Avenue 3.3L No Start VIN: 1C3XV66R2N
Thank you all for your valued information. I did all the test recomended, found the correct voltage at the pump finally after I did it correctly (thanks to you guys). Since I had good voltage and no pump action, no codes for crank sensor or any other codes I r...
|1999 Chrysler 300M 3.5L engine VIN: 2C3HE66G7X
Thankyou to all that sent replies, the car has a few issues, I kept the vehicle and ran it at the shop for over 2 hours, the vehicle finally stalled and I had a fuel pressure gauge on it, the fuel pump had heated up and cause the pressure to fail, that was the...
|2000 Chrysler Sebring LX 2.5L Heads VIN: 4C3AG52H71
We got it back together. It had some performance problems that needed to be resolved before I could post the fix. Thank You ALL.
|1988 Jeep Cherokee 4.0L boot VIN: 1JCML7816J
hi thanks to all who replied. Robert from Iowa hit it on the head. it seemed like a simple problem but nobody in our shop could rember how it came off and not wanting to destroy something i made a post. thanks again to all who replied. kyle